Agrimate AMTH-PRO-K-2S Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Agrimate AMTH-PRO-K-2S. Agrimate AMTH-PRO-K-2S 20 pagina's.

Pagina afdrukken
The space between the edges can be adjusted as following:
•
Unscrew the nut
•
Use the plus driver to screw the screw to the end lightly and then turn back 3/8 round
•
Screw the nut tightly. The adjusting washer should be flexible.
•
Add the lubricating oil on the blades.
•
Start the gasoline engine and let the blades work at high speed for 1 minute.
•
Switch off the gasoline engine and touch the nut. If hands can undergo the temperature,
it means the adjustment is successful. If hands feel hot, loosen the crew for a little,
and adjust it until it is OK. (Notice: Please adjust it when the machine is shut off. The
screw should be in the narrow hole. If there is dirt in it, please clean it.)
3.
Keep the air-feed system clean
4.
Cleaning of the carbon in the spark plug and adjustment of the space. Every 25 hours
after working, please take off the spark plug and clean it. Adjust the space between the
electrodes (0.5~0.6 mm).
5.
Dismantle the air cleaner after 15 hours' work. Use the gasoline to clean it thoroughly.
Then dry and reinstall it. Dismantle the casing lid: clean the carbon and the dirt.
6.
Cleaning of carburetor. When working on the bad conditions, carbon powder and dusts
on the tree may contaminate the machine, so besides cleanings after work every time,
cleanings after every 100 hours' work are necessary. (Cleanings must be held when the oil
box is switch off.)
(Note: The inside parts has matched the machine, please do not adjust it freely.)
7.
No use for long time
•
When the machine is cool off, let the fuel go out and press the oil pump so the fuel
remaining in the pump goes back to the oil tank. At last, empty the fuel in the oil tank.
•
Take off the spark plug, and drop the oil into the hole. Pull the starter so the oil covers
the inner well. Put the spark plug back.
•
Clean outside parts, blades and blade edge press-pieces of the machine. Put it in a dry
room.
Problematic parts need repair. Necessary repairs must be committed to the appointed
repairer in the authorized shop.
5