Dynalite Baja Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dynalite Baja. Dynalite Baja 12 pagina's. Portable electronic flash
Ook voor Dynalite Baja: Gebruikershandleiding (16 pagina's)
Pagina afdrukkenGeng Started
Dynalite Baja Portable Electronic Flash units ship with a hard plastic cover that
protects the ashtube. Press the Accessory Release (18) at the top front of the
unit then twist the ashtube cover counterclockwise. When it stops after about an
eighth of a turn, pull the cover away from the unit.
Charging the Baja
Connect the charger s output cord to the Charging Socket (10.) Plug its AC cord to
110 / 240 volt outlet. Turn the Power Switch ( 8 ) O.
The indicator light on the charger glows Red while the Baja is charging. It turns to
Green when the battery is full.
Fully charge the battery before using your Dynalite Baja B-4. This takes about three
and a half hours. When the battery is fully charged; the Battery Status (12) will show
Full. The Dynalite Baja s battery can be augmented by connecting the charger to
the Charging Socket (10) while the unit is being used increasing the number of full
power ashes to 800.
Flash Modes
The Dynalite Baja B-4 oers four ash modes: Normal, High Speed Sync (HSS) Short
Duration and Stroboscopic. Here s a detailed explanation of each one.
Normal
Normal is the mode used most often. It provides a six f/stop range of power in one
tenth of a stop increments from 1.0 (lowest power) to 7.0 (six f/stops brighter.) The
chart below shows the power ratings on the Main Display (13) (top row) with the
watt / second (w/s) output for each setting (middle row) and the color temperature.
f/stop range of power
1.0
watt/sec output
6 w/s
color temperature
5420ºk
8
2.0
30.
4.0
12 w/s
25 w/s
50 w/s
5480ºk
5560ºk
5600ºk
5.0
6.0
7.0
100 w/s
200 w/s
400 w/s
5590ºk
5500ºk
5500ºk
Main Display
13
12
10
Battery Status
High Speed
Mode Button
Flash Control Dial
1
4
7
Test Button
8
Power Switch
Charging Socket