Gainlab Audio GLA-TC2 Handmatig - Pagina 7
Blader online of download pdf Handmatig voor {categorie_naam} Gainlab Audio GLA-TC2. Gainlab Audio GLA-TC2 13 pagina's.
Ook voor Gainlab Audio GLA-TC2: Kalibratiehandleiding (18 pagina's)
Pagina afdrukken
compared to the original signal. To select the operating mode, move the switch
until the indicator LED shows the desired operating mode.
TIME CONSTANT - ATTACK
the maximum of its intervention range when approaching the set intervention
threshold level. To change the speed at which the procedure rises, move the
switch labeled ATTACK down to set a slower procedure, or move it up to set a
faster procedure. As it is an electron tube circuit, the time constants are
difficult to express in an exact way. The following table helps to determine the
approximate time of the ATTACK parameter:
FASTEST
FAST
SLOW
TIME CONSTANT - RELEASE
switch labeled RELEASE down to set a slower procedure, or move it up to set
a faster procedure.
FASTEST
FAST
SLOW
DICTATOR DUAL MONO VARI-μ
The sound we hear during compression is basically
determined by the speed of the time constants, which in
most cases will result from the nature of the program
signal.
The time constant marked ATTACK can be used to
determine how long it takes for the compressor to reach
15ms
25ms
40ms
The RELEASE parameter determines how long it takes
for the compressor to complete the intervention if the
input signal level falls below the set intervention
threshold level.
To change the run speed of the procedure, move the
200ms
350ms
55 0ms
6