Gree 13-04686 Gebruiksaanwijzing - Pagina 15
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Gree 13-04686. Gree 13-04686 20 pagina's.
Pagina afdrukken
Remote Control
1
ON/OFF
Press this button to turn on the unit. Press
this button again to turn off the unit.
2
MODE
Each time you press the button, a mode is
selected in a sequence that goes from
AUTO,COOL,SAVE, FAN and DRY, as the
following:
3
– :
Press this button to increase set tempera-
ture. Holding it down above 2 seconds
rapidly increases set temperature. In
AUTO mode, set temperature is not
adjustable.
+ :
4
Press this button to decrease set tempera-
ture. Holding it down above 2 seconds
rapidly decreases set temperature. In
AUTO mode, set temperature is not
adjustable.
5
FAN
This button is used for setting Fan Speed in
the sequence that goes from
AUTO,
to
then back to
Auto.
NOTES : There are 3 speeds for the Fan
Speed of this model.
6
6
I FEEL
I feel function will be action if pressing
this button.
If controller receives I FEEL order, it will
work under ambient temperature value
which sending by remote controller, and
remote controller will send ambient tem-
perature value to controller every 10min.
After 11min, if controller does not receive
ambient temperature value which sending by
remote controller, it will run with
AC ambient temperature; if I FEEL is not set,
ambient temperature will adopt sampling
value of AC temperature sensor. If power off
happens, this function will not be memo-
rized.
7
SLEEP
Press this button to go into the SLEEP opera-
tion mode. Press it again to cancel this func-
tion. This function is available in COOL,
HEAT (Only for models with heating func-
tion), Energy Saver or DRY mode to maintain
the most comfortable temperature for you.
8
TIMER
Press this button to initiate auto-on/auto-off
timer. To cancel auto-timer program, press
this button twice.
9
Combination of "+" and "-" buttons:
About lock :
Press "+ " and " - " buttons simultaneously to
lock or unlock the keypad. If the remote con-
troller is locked,
is displayed. In this case,
pressing any button,
blinks three times.
10
Combination of "MODE " and "-" buttons:
About switch between fahrenheit and cenri-
grade
At unit OFF,press" MODE "and" - "buttons
simultaneously to switch between °C and °F .
11
Combination of "+" and " FAN" buttons:
About Lamp
Under switch-on or switch-off state, you may
hold "+" and "FAN" buttons simultaneously
for 3 seconds to set the lamp on or off and
send the code. After being energized the
lamp is defaulted on.
12
About Energy saving
Under energy saving mode, lamp of energy
saving mode is on, and the temperature set-
ting range is 61~86 °F(16~30°C). The buzzer
will give out a beep if remote control turbo
speed by F remote controller, and runs with
high speed.
Note : This is a general use remote controller,
it could be used for the air conditioners with
multifunction; For some function, which the
model doesn't have, if press the correspon-
ding button on the remote controller that the
unit will keep the original running status.
15