Gainsborough G+ LOCKSET Handleiding voor installatie-instructies - Pagina 4

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Gainsborough G+ LOCKSET. Gainsborough G+ LOCKSET 8 pagina's. G+ series for the apex electric locksets and volt electric locksets

Pagina afdrukken

Task 2

Battery Box

height marking

Strike

Latch height

Template in

marking

middle of Strike

1/2 door

thickness

1/2 door

thickness

CaUTION: The door drilling templates are different for the

G+ Volt and the G+ apex style locksets.

Please ensure that the correct template is used. The template

is clearly marked "VOLT" or "aPEX".

• Fold template where indicated (make sure the correct

template is used).

• Position template on door edge with the template on the

INSIDE door face. Close the door while holding template

to door face. Line up the latch centreline on the template

with the MIDDLE of the strike on the door frame.

• Firmly hold template and mark on door face the hole centre

points. Without moving the template, open the door and

mark latch height and Battery Box height on door edge.

• Remove template and measure door thickness. Divide this

size in half and mark centre of door on Battery Box height

and latch height markings.

A • Drill 1 inch hole 85mm deep in 3 places on door edge.

NOTE: It is important to drill holes squarely.

• Chisel wood to join the 2 Battery Box holes.

B • Drill 10mm door face holes in 7 places, drilling from

both sides of the door.

C • Drill pilot holes for larger holes in 3 places (suggested

size 3mm), drilling from both side of the door.

• Enlarge the 3 pilot holes to 54mm, drilling from both

sides of the door.

D • Mark and chisel a recess of 4mm for the Battery Box

faceplate. (So that Battery Box faceplate is flush with

the door edge). Use the Battery Box as a template.

• Mark and chisel a recess of 4mm for the latch faceplate.

(So that the latch faceplate is flush with frame the door

edge). Use the latch as a template.

• Insert the latch making sure that the tapered (bevelled)

side of the latch faces towards the door frame when the

door is open.

• Fix using 2 wood screws from KIT A.

• Insert the Battery Box.

The wires exiting the Battery Box should face towards

the outside of the door. Wrap the wires over the top of the

Battery Box and pass the connector through the top hole

on the inside door face. (The wires will now be coming

through to the inside). See Step 11.

• Fix using 2 black wood screws from KIT D.

NOTE: Do not over tighten these screws. Do not use power tools.