Gainsborough TRILOCK G1 Series Installatie-instructies

Blader online of download pdf Installatie-instructies voor {categorie_naam} Gainsborough TRILOCK G1 Series. Gainsborough TRILOCK G1 Series 4 pagina's. Eclipse dummy, suits 35mm to 45mm door thickness
Ook voor Gainsborough TRILOCK G1 Series: Installatie-instructies (2 pagina's)

Pagina afdrukken

Installation Instructions for 8955 BB Series Omni Trilock

Twin Pull Handle Version - Suits 35mm to 45mm door thickness

Step 1.

• Fold template where indicated.

• Position template on door edge at

desired lock / latch height.

• Firmly hold template and mark latch

height and 2 off 60mm holes centres.

• Measure door thickness and mark

centre on 'latch height' marking.

• Drill 22mm (7/8") latch hole.

Note: it is important to drill this

hole squarely.

• Drill pilot holes [suggested size

3mm (1/8")]. Then enlarge holes to

60mm, drilling from both sides of the

door.

In particular, ensure the 60mm dia.

holes through door face are drilled

only to this size, otherwise correct

functioning may be impeded –

refer template.

Step 3.

• Mark and chisel latch faceplate to a recess of 2.5mm.

Use latch carrier as a template.

• Insert lock body into 60mm (2 3/8") slot.

• Insert latch carrier through 22mm

(7/8") hole into lock body assembly

and tighten with 2 screws.

Ensure T-shaped hole at rear

of latch carrier is upright!

Lock

body

Step 4a

Trilock Latch Bolt re-handing.

• Check that tapered side of the

Latch bolt faces towards the door jamb.

• It may be necessary to unclip

the rear arm & rotate bolt 180

• This is achieved by following steps:

NOTE: • carefully follow these instructions when installing.

• do not overtighten screws.

• use of power driver is not recommended.

• fully remove the Trilock prior to painting the door

to avoid harming the product's finish.

PAIT 147

NOV '12

Please note: Ensure the template

position and orientation is as shown,

incorrect installation voids warranty.

T Shape hole

Rear view

of latch

Arm

1. Remove Latch bolt assembly from carrier

Rotate Bolt 180˚

4. Rotate Bolt 180˚

Step 2.

• Mark vertical lines between

two holes as per illustration.

• Cut along marked lines

Mark vertical lines between holes

as shown. Cut along vertical lines

Step 4.

• Insert the latch through the slot in the carrier until it can go no further.

• Insert the key and turn to retract the latch bolt.

• Pre-drill wood screw holes with suitable drill size.

• Install plastic faceplate shim and faceplate, then screw into position.

Latch

carrier

2. Rotate arm down wards

5. Re-attach arm to latch bolt

Patent Pending

3. Unclip arm from latch bolt

6. Rotate arm up wards &

fit back into carrier