Dynamatic 4050 Instructieblad

Blader online of download pdf Instructieblad voor {categorie_naam} Dynamatic 4050. Dynamatic 4050 15 pagina's. With dancer position
Ook voor Dynamatic 4050: Instructieblad (13 pagina's), Instructieblad (14 pagina's), Instructieblad (13 pagina's)

Pagina afdrukken

Instruction Sheet

IS-539-11

revised 2019

15-533-1011 Panel Mount 4000 (3.5 A Controller)

15-351-1011 Standard Enclosure 4000 (3.5 A Controller)

15-539-0011 Panel Mount 4050 (8 A Controller)

15-553-0011 Standard Enclosure 4050 (8 A Controller)

Model 4000 and 4050 with Auto Manual Low Signal Follower

Introduction

These instructions relate specifically to the

model 4000 and 4050 controllers assembled for

Speed Control with Auto/Manual Low Signal

Follower (Ext Ratio) modification. Connection

diagram,

schematic

programming,

plug

adjustment procedure and recommended spare

parts list for these specific assemblies are

contained in this Instruction Sheet. Any

differences between these two controllers are

clearly noted. Use Instruction Manual IM-

130006-83XX with this Instruction Sheet for

complete

installation,

maintenance instructions.

Caution: Above ground electrical potentials can

be hazardous. Always disconnect electrical

power before working on the controller.

*Heat sink assembly, HS1, and its wiring only

apply to the Model 4050 controller. These parts

are not supplied on Model 4000 controllers. The

parts are mounted on the 15-530-5 main 4000

boards.

Model 4050 Controller Panel with Auto/Manual Low

Signal Follower (Ext. Ratio) Modification board 15-446-5

15-539-11

External Ratio Adjustment

diagram,

switch

wiring

connection,

operation

and

Drive Source International/Dynamatic

7900 Durand Ave Bldg 3 Sturtevant, WI 53177

[email protected]

800-548-2169 •