DynaMetric TRI-807 Instructies - Pagina 2

Blader online of download pdf Instructies voor {categorie_naam} DynaMetric TRI-807. DynaMetric TRI-807 2 pagina's. Telephone recorder interface with beeps audio, beeps and handset off when on-hook

Pagina afdrukken

Instructions

TRI-807* Telephone Recorder Interface with Beeps

Audio, Beeps and Handset OFF when ON-HOOK

P/N 43430 B Series

Temporarily install, with light pressure, the silver target on the side of the handset earphone

adjacent to the TRI-807. Adjust the position of the TRI-807 housing (raise, lower or slide) so the

apertures in the housing are aligned with the target on the handset so that when ON-HOOK the

LED is out and OFF-HOOK the LED is ON. Adjust the target position if necessary. When aligned,

press the adhesive pads of the target and the housing firmly against the phone for permanent

location.

With the handset ON-HOOK, the LED is out, the handset is muted, beeps are OFF and no audio

goes to the recorder. With the handset OFF-HOOK, the LED is lit, the handset operates normally

and audio and beeps go to the recorder. If these conditions are met, the unit is properly aligned

and correctly installed.

* These instructions also apply to TRI-807P, P/N 43839, which is used where more than one unit

is connected to recorder channel.

Patent # 5,835,585

FOR LEGAL USE ONLY

9-17-01

www.DynaMetric.com

Page 2 of 2