Celestron PowerSeeker 114EQ Handleiding voor snelle installatie - Pagina 2

Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Celestron PowerSeeker 114EQ. Celestron PowerSeeker 114EQ 2 pagina's. Celestron powerseeker 50: brochure
Ook voor Celestron PowerSeeker 114EQ: Gebruiksaanwijzing (10 pagina's), Handleiding voor snelle installatie (2 pagina's), Specificaties (4 pagina's), Brochure & specificaties (4 pagina's), Handleiding voor snelle installatie (2 pagina's), Handleiding voor snelle installatie (10 pagina's), Handleiding voor snelle installatie (2 pagina's)

Quick Set-up Guide [cont]

Locate the counterweight bar and counterweight. Slide the

counterweight half way down the counterweight bar and

tighten the locking screw to secure in place.

The longer cable should attach to the Right Ascension axis

and the shorter cable attaches to the Declination axis --

tighten screw to secure in place.

Reattach both knobs and tighten to secure in place. The

focuser end of the telescope should be over the

counterweight assembly.

Loosen the screw on the focuser so that it does not obstruct

the inner diameter of the focuser. Remove the plastic cap

covering the end of the focuser.

For additional magnification, you can use the included 3x

barlow. Place the barlow in the focuser in place of the

eyepiece - remove the cap from the barlow.

All manuals and user guides at all-guides.com

Thread the threaded end of the counterweight bar into the

Dec axis of the equatorial mount.

Before mounting the tube, remove the two knobs on the tube

rings.

Locate the finderscope and remove plastic caps on front and

back of lens. Remove the knurled nuts on the threaded posts

at the focuser end of the telescope tube.

Insert the chrome barrel of the 20mm eyepiece into the

focuser and tighten the screws.

Place the eyepiece into the barlow and tighten the set screw

to secure in place.

Slide the chrome end of the slow motion control cables onto

equatorial mount gear shaft and tighten screw to secure in

place.

Place the tube on the mount by lining up the screws with the

mounting holes on the mount.

Orient the finderscope so that the glass window is facing

towards the front of the tube. Place finderscope over the

posts on the tube and tighten it down with the knurled nuts.

Remove the lens cap from the front of the telescope. To

observe, look through the eyepiece as shown above.

For detailed usage

information please

consult your owner's

manual.