ActiveProducts XE06 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ActiveProducts XE06. ActiveProducts XE06 10 pagina's. 1600 psi electric pressure washer

Pagina afdrukken
ASSEMBLY AND OPERATING INSTRUCTIONS
3
Gently pull detergent container out of storage position, and fill
with detergent. Push containers back into storage position.
4
Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will automati-
cally mix with water, and be discharged through the nozzle at low pressure. Apply detergent
to a DRY work surface, from bottom to top.
5
Allow detergent to remain on the surface for a short time before rinsing. Do not allow
detergent to dry on surface.
6
Rinse with clean water under high pressure. On a vertical surface, rinse from the
bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8" (15-20
cm) from the work surface, at a 45° angle.
7
When you have finished using the detergent injection system, fill detergent bottle
with clean water. Siphon water at low pressure for one minute, so that all detergent is
flushed through system. Remove detergent bottle, and rinse it thoroughly.
CAUTION
Damage may occur to painted surface if chemical is allowed to dry on surface. Wash
and rinse a small section at a time. Avoid working on hot surfaces or in direct sunlight.
11
ASSEMBLY AND OPERATING INSTRUCTIONS

SHUTTING DOWN AND CLEANING UP

1
(If you are not using detergent, go directly to Step 2.) When you have finished using
the detergent injection system, fill detergent bottle with clean water. Siphon water at
low-pressure for one minute so that all detergent is flushed through system. Remove
detergent bottle and rinse it thoroughly.
2
Turn the switch to "OFF" (0) position.
3
Unplug the power cord from the outlet.
4
Turn off the water supply.
5
Press trigger to release any remaining water pressure.
6
Disconnect the garden hose from the water inlet on the unit.
7
Engage gun safety lock.
WARNING
Turn off water supply and squeeze trigger to depressurize the unit. Failure to do so
could result in personal injury due to discharge of high-pressure water.

TAKING A BREAK

If taking a break of five minutes or more:
1
Engage gun safety lock.
2
Turn unit to "OFF" (O) position.
3
Unplug the power cord from the outlet.
CAUTION
Failure to clean properly will cause the detergent injection system to become
clogged and inoperable.
CAUTION
Never use:
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e., paint thinners, gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the surface being cleaned.
12