ADEMCO 5806 Installatie-instructies - Pagina 3
Blader online of download pdf Installatie-instructies voor {categorie_naam} ADEMCO 5806. ADEMCO 5806 5 pagina's. Smoke detector with built-in wireless transmitter
Ook voor ADEMCO 5806: Installatie-instructies (4 pagina's)
Pagina afdrukken
Note: I
Programming
Tamper Protection
INDEXING
9 VOLT
BATTERY
MARK
COMPARTMENTS
INDEXING
MARK
HOLDING TABS.
LOCKING TABS ON MOUNTING PLATE SLIDE BENEATH
THESE TABS (DETECTOR IS LATCHED ONTO MOUNTING
PLATE BY TURNING CLOCKWISE)
Figure 1.ÊÊBottom View of Smoke Detector (without mounting plate)
Battery Reset
PROGRAMMING
LOCATION OF ÒLEARNÓ BUTTON
AND ÒTAMPERÓ JUMPER
"LEARN" BUTTON
"LEARN"
(INSIDE OPENING).
PUSH (WITH SMALL
BUTTON
SCREWDRIVER) TO
SEND "FAULT".
PLACE LIGHT
CUT JUMPER
PENCIL MARK
FOR TAMPER
HERE*
*
ONLY IF TAMPER
MAGNET WILL BE
REED SWITCH
USED
BATTERY RESET
MAGNETIC REED
SWITCH.
SWITCH
(PRESS AFTER
INSTALLING
BATTERY RESET SWITCH.
BATTERIES)
(PRESS AFTER INSTALLING
BATTERIES)
Mounting The Smoke Detector
NFPA
RECOMMENDATIONS REGARDING
SMOKE DETECTOR INSTALLATION
RECOMMENDED LOCATIONS FOR
SMOKE DETECTORS
TESTING THE SMOKE DETECTOR.
Mounting Locations
LOCKING TABS
INDEXING MARK
(USED FOR SECURING
SMOKE DETECTOR
TO MOUNTING PLATE)
SLOTTED HOLES
FOR MOUNTING
SCREWS
(10 cm)
4 IN.
CEILING
DEAD AIR
BEST IN
ACCEPTABLE
SPACE
4 IN.
CORNER
HERE
(10 cm)
NEVER
HERE
ACCEPTABLE
HERE
6 IN.
(15 cm)
NOTE:
MEASUREMENTS
SHOWN ARE TO THE
CLOSEST EDGE OF
THE DETECTOR.
SIDE WALL