Gait up Physilog 5 Gebruikershandleiding - Pagina 7
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gait up Physilog 5. Gait up Physilog 5 17 pagina's.
Ook voor Gait up Physilog 5: Gebruikershandleiding (12 pagina's), Gebruikershandleiding (17 pagina's)
Pagina afdrukken
To benefit from the maximal battery life, fully charge Physilog® sensors before doing
measurements (LED shines green when connected to computer or charger, you can also check
with the App).
Copy trial recordings to your computer: Physilog® is not the best place to keep important data.
Physilog®5 can be used outside. But do not use Physilog®5 to measure water-sport activities
without additional waterproofing.
Do not introduce pointy objects into the small hole besides the USB entry, this irreversibly
damages the waterproofing of the sensor.
Storage: Store in a cool (0°C – 30°C) and dry place. The provided box is the perfect place for your
sensor.
Cleaning: Sensors can be cleaned gently using alcohol wipes. Before you clean the device make
sure it is turned off and disconnect all cables. Alcohol used in excess may damage the sensor's
waterproofing. Make sure to use wipes and not put liquid alcohol directly on the sensor.
Sensors do not need yearly recalibration.
Do not throw Physilog® sensors in the normal trash, dispose of it properly considering local laws
and rules about electronic waste and batteries. Contact Gait Up's customer support for more
information about elimination of Physilog®.
Make sure to know which Physilog® file corresponds to which trial for your analysis – First digits
of file name are automatically incremented for each day of measurement (exceeding 999 resets
the increment back to 1). Note that date of file generation (recorded between one start and stop
of the Physilog®) is visible in the XLS or CSV file and the Matlab structure "header". If you wish
to adapt internal date and time of the Physilog®, read section below.
Do not remove the "conf.bin" file from the Physilog, otherwise it will create empty files (no
sensor activated). If this happens, recreate a configuration in the Research ToolKit software or
contact Gait Up's customer support. For firmware v1.1.0 upwards, a default configuration based
on original configuration is created to compensate the removal of the conf.bin file.
Physilog5 user manual v1.2.6 Date: 19.06.2018
Copyright © 2018, All Rights Reserved - Gait Up SA. CH-1015 Switzerland
EPFL Innovation Park, Bat C. CH-1015 Lausanne
TVA CHE-145.136.760
Gait Up SA
www.gaitup.com
7