DYNAMIC DIAMOND TOOLING DDV26 Handmatig - Pagina 6

Blader online of download pdf Handmatig voor {categorie_naam} DYNAMIC DIAMOND TOOLING DDV26. DYNAMIC DIAMOND TOOLING DDV26 16 pagina's.

5. FILTER CLEANING

The filter must be cleaned from time to time. This must be done before changing the

bag collection system and should also be done when work is completed or when

there is poor suction.

Procedure:

1. Push down the damper , cover the inlet.

2. Turn on the machine and wait 3 seconds, let the

machine build up vacuum.

3. Quickly push down on the key and wait 3 seconds.

4. Repeat the procedure five times.

5. Turn off the motor and wait until it stops completely,

then uncover the inlet.

！！！It is important to wait 4 to 5 seconds in between every repetition.

If suction remains poor, the pre-filter needs to be replaced. If suction still remains

poor afterwards, the HEPA filters needs to be replaced. See instructions in chapter 6.

The dust extractors are mainly equipped with continuous folding bagging system for

effective dust storage or a regular plastic bag system depending on model. The

continuous bag is a 72ft long plastic tube that will be divided into plastic bags using the

zip ties attached with the machine.

To assemble a new continuous bag:

Release the belt holding the last bag. Remove the holder, put in a new bag & pull out

the inner end upwards. Assemble the holder on to the machine and strap the opening

facing upwards with the belt. Pull down the outside end and close it using a zip tie.

All dust extractors can be used with continuous folding dust bags for single use. Also all

models can be fitted with the continuous bag system.

Only change continuous bag or regular bag after filter cleaning cycle have been

completed.

To operate the continuous bag:

7. FILTER CHANGE

Risk of dust dispersion - Use personal safety equipment

Unhealthy dust can be spread during filter change. Accordingly, the user should wear

protective glasses, protective gloves, and a breathing mask conforming to protection class

FFP3.

1. Assemble the continuous bag, turn on the

machine.

2. Turn off the machine, the dust will drop down

to the bags.

3. Use a nylon tie to seal the bag

4. Cut the bag