Gakken SX-150 Montage- en gebruikshandleiding

Blader online of download pdf Montage- en gebruikshandleiding voor {categorie_naam} Gakken SX-150. Gakken SX-150 4 pagina's. Analog synthesizer

Pagina afdrukken

Assembly time: Approximately 20 minutes

(The electric circuit comes pre-assembled,

so there is no need for soldering.)

Things you will need

Phillips screwdriver (No. 1)

AA alkaline batteries

(4 new)

* Please note that rechargeable NiCd

batteries and non-rechargeable Oxyride

and nickel-based batteries should not be

used due to a high risk of components

melting or fire breaking out with these

batteries because of accidental

short-circuiting or the like. Additionally,

because this supplement was designed

based on operation at 6 V, it may not

operate in the desired way due to an

excess of or a deficiency in voltage with

the above batteries. Incidentally, most

rechargeable batteries provide 1.2 V and

Oxyride batteries, 1.7 V.

Cellophane tape

Notes for tightening

screws

The types of screws used for the

supplement are those that carve grooves

into the plastic as they are inserted

(self-threading). The screwdriver most

suited to tightening the screws is the #1 JIS

screwdriver. When tightening screws,

firmly press the provided screwdriver

straight against the screws and turn.

It is said that 70 percent of the force

applied is used for pushing against the

screw and 30 percent for turning it.

Precision screwdrivers are hard to turn, so

use a small screwdriver with a grip

diameter of about 2 cm.

Full-scale image

of a #1

screwdriver

Plastic materials used in this kit

Main unit/knobs: HIPS

Electrode handles: PE

Printed circuit boards/slider panel: Phenolic

resin

Metallic materials used in this kit

Electrodes: Iron (nickel plating)

Screws: Iron

Parts in the Kit

Circuit

board

Slider panel

CAUTION

Please be sure to read the following instructions before assembling this kit.

● Take necessary caution when handling parts with pointed edges. There is a risk of injury.

There are many parts with pointed edges on the back side of the circuit board, so please take care that you do not get injured by getting a finger or

other body part caught on one of the sharp edges.

This kit includes screws and other small parts. Be careful not to swallow them. There is a risk of suffocation.

This supplement uses AA alkaline batteries. Incorrect use of the batteries may cause the generation of heat, explosions or liquid leakage.

The following precautions should be taken.

● Please note that rechargeable NiCd batteries and non-rechargeable Oxyride and nickel-based batteries should not be used.

● Ensure that the positive and negative terminals of the batteries are aligned correctly.

● If liquid that leaked from the batteries gets into your eyes, rinse them well with plenty of water and consult a doctor immediately.

If liquid leaks onto your skin or clothes, wash it off immediately.

● Always remove the batteries after use.

● Please read the instructions and cautions thoroughly before trying it out.

● For your safety, be sure to follow the instructions in this manual. In addition, do not use any parts that have become damaged or deformed during

use.

● Always remove the batteries after use and place them in a location out of the reach of small children.

How to Assemble and Use the Supplement

Knobs (5)

Speaker

(Wrapped in cardboard.)

Analog Synthesizer

Washer head screws (7)

Screws (3)

Main unit

Electrode

Cut out the cardboard

case to use as a back

cover.