GALA mitta Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} GALA mitta. GALA mitta 12 pagina's. Hydromassage bathtubs
Ook voor GALA mitta: Gebruikershandleiding (16 pagina's), Installatiehandleiding (12 pagina's), Gebruikershandleiding (16 pagina's), Handleiding voor installatie-instructies (12 pagina's)

INTRODUCTION

Gala hydromassage baths are manufactured using top quality materials. Before reaching its destination,

each hydromassage bath has been subjected to strict technical and safety controls.

In order to ensure the correct operation of your hydromassage bath, please follow the instructions below:

1. The installation must be carried out by qualified personnel and in accordance with the current

regulations of each country.

2. The bath's protective elements must remain in place until the installation work has been completed in

order to prevent the risk of damage. The bath must be lifted by its frame, not dragged or lifted by its pipes.

3. Before installing the bath, check that no damage has occured during transportation or handling.

BATHTUB INSTALLATION

The hydromassage bath must be installed in accordance with the INSTALLATION INSTRUCTIONS

corresponding to each model, which are enclosed with the bathtub, paying special attention to the

following points:

1. Before installing the bath, fill it with water and check that there are no leaks and that all the

hydromassage bath elements operate correctly.

2. When applying silicone respect the indicated measures in order to avoid the small vibrations that can

cause the motor of the bathtub during the normal functioning

THE BATHTUB MAY BE FRONTED IN TWO DIFFERENT WAYS:

1- MASONRY WALL

1. Take care to leave a 2-3 mm. space

between the bath and the wall in order to

be able to seal the joint with silicone

(Fig. 1).

2. The motor area must be enclosed, but

accessible for possible repairs. A grille

must also be provided for ventilation of

the hydromassage bath equipment.

3. The motor access hatch must be at

least 70 x 45 cm. minimum, so that tools

will be required to open it (Fig. 2).

4. The grille on the access hatch must be

at least 200 cm in size. The grille

openings must be finger proof.

Installation manual

English