Dynamic Precision DPA 6.4 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dynamic Precision DPA 6.4. Dynamic Precision DPA 6.4 13 pagina's.

Note:

All cables to be connected prior to turning the power on. The pre-

amplifier, crossover network or any other equipment shall be

turned on prior to the power amplifier.

SIGNAL INPUT AND OUTPUT TERMINALS:

This power amplifier is equipped with electronically balanced inputs using XLR-terminals (female).

Pin allocation is as follows:

• Pin 1 = GND/shield

• Pin 2 = signal (+) in phase

• Pin 3 = signal (-) anti-phase

DPA 6.4 also has a set of (L and R channels) XLR-terminals (male) in parallel with the input terminals.

These terminals shall be used when paralleling L and R channels or paralleling several DPA 6.4s. A

specially prepared cable shall be used when paralleling or bridging DPA 6.4s, see pages 7 and 8.

LOUDSPEAKER TERMINALS:

The amplifier is equipped with 4 sets of binding post (screw fastening terminals).

FUSES:

A defective fuse shall only be replaced by an equivalent fuse.

Using a fuse with an incorrect value can cause serious damage to the amplifier which is not

covered by the warranty, and could start a fire.

DPA 6.4

CABLES AND CONNECTIONS

Figure 2. DPA 6.4 back panel.

CONNECTIONS

PAGE