Celexon HomeCinema CLR UST Gebruiksaanwijzing - Pagina 3
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Celexon HomeCinema CLR UST. Celexon HomeCinema CLR UST 11 pagina's. Electric floor high contrast screen
Ook voor Celexon HomeCinema CLR UST: Gebruiksaanwijzing (12 pagina's)
Pagina afdrukken
•
Suspended loads must be checked for strength and load-bearing capacity at least
twice a year.
•
Children should not use the screen or play under it unsupervised.
•
Caution: Risk of injury! The unit closes flush and firmly in its retracted state, keep
fingers, hands or other small parts away from the opening.
•
All supply lines and cables must not be subjected to additional loads and must be
laid in such a way that they are not damaged or crushed.
•
Failure to observe the above instructions may result in personal injury and damage
to the product or equipment connected to it. Incorrect installation or use may also
invalidate the warranty.
•
If you are unsure about the use of the product, please contact specialist personnel,
your dealer or celexon directly (Web: www.celexon.co.uk, Mail: [email protected]).
•
Technical changes and errors expected.
The manufacturer accepts no responsibility for damage to property or personal
injury, if the screen is used outside the recommended specifications, or in the event of
improper installation. Do not use this screen in the vicinity of heaters or air conditioners.
Also, do not mount the product in direct sunlight or in front of a window. Due to the
temperature-sensitive PVC surface, the projection screen fabric may be permanently
damaged.
We recommend that you wait approx. 2 hours after delivery before installing the
projection screen. This way you will allow the screen to acclimatise, especially when
moving from a cold to a warm environment (or vice versa).
Please avoid any stains on the surface of the screen. These may not be able to
be removed.
The positions of the end points are already optimally set at the factory and should
not be changed. Especially with electric screens, the entire length of the fabric should
always be used in order to achieve the best flatness. An adjustment of a few cm of
the end points should only be made by persons with specialist knowledge and in
consultation with the manufacturer. Incorrect adjustment can result in damage to the
projection surface.
2