HiFiMAN ANANDA-BT Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} HiFiMAN ANANDA-BT. HiFiMAN ANANDA-BT 14 pagina's.
Pagina afdrukken
ANANDA-BT
Owner's Guide
3.5mm microphone interface
Power button
In playback mode, tap the power button once to start/pause playback.
To answer a call, press the power button once to answer. To reject,
please press and hold the power button 2 seconds. Press twice quickly
to finish the call.
Press power button for 8 seconds continuously to reset the
headphones when it cannot pair normally.
USB charging / playback port
Charge button
Operation Guide
To connect over Bluetooth for the first time, press the power button for
1 to 2 seconds to turn it on. Once the blue light flashes twice to indicate
that the power is turned on successfully, Press the power button twice
to enter the pairing mode. The light will flash blue and green alternately.
At this point you should find HIFIMAN-BT-ANANDA in the device's
Bluetooth connection list. Click Connect to complete the pairing.
To connect a paired Bluetooth audio output device, simply press the
power button for 1 to 2 seconds to turn it on. The blue light will continue
to flash at intervals. If the previously paired Bluetooth device is turned
on, it will try to connect automatically (the maximum number of
memory connected devices is 8; if no device is connected for more
than ten minutes after the headphone is turned on, it will automatically
shut down).
Press power button for 5 seconds to turn off.
To charge, connect the USB charging cable to the power supply and
headphones then press the charge button for 2 seconds. While charging
the red light be solid and once fully charged the light will turn green.
In normal working condition, the blue light of the headset will flash.
If the battery is low, a red light will flash.
To enable the USB playback mode simple connect the audio device
with a usb cable to enter USB mode without charging. The light will be
all white in this mode. After connected, you can also press the charge
button for 2 seconds to enter USB mode with charging. White light will
be solid, and red light will flash every 3 seconds. The green light will
flash every 3 seonds when charging completed. To exit USB playback
mode, simply move the USB cable. After exiting, the headset will
resume Bluetooth mode and the blue light with flash.
N.B: USB playback mode can be used only if the audio playback
device and USB cable support audio playback. The type of USB cable
may affect playback quality.
* When using computer as the audio input device, no need to setup any
driver when the OS is WIN10 or MacOS. For the OS WIN 8 and below ,
please turn to hifiman.com service & support to download suitable driver
for Ananda-BT. If connected to devices like mobile phones or some
other portable player device without power supply, it may finish the
battery very soon. Not all the devices can be connected by USB mode.
11-12