Hifionics Zeus ZXI60.4+1K Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Hifionics Zeus ZXI60.4+1K. Hifionics Zeus ZXI60.4+1K 14 pagina's.

Pagina afdrukken

ZXi200.2 2-CHANNEL AMPLIFIER APPLICATIONS

FULL RANGE STEREO

This is the most basic application for the HFi Series 2 channel amplifiers.

1. Interconnect cable checklist:

Connect the LINE INPUTS to the Radio/CD with good quality RCA cables.

2. Crossover Switch:

The X-OVER switch must be in the FULL position.

3. Crossover frequency control checklist:

N/A for full range operation.

FULL RANGE

STEREO LINE INPUT

MONO

This application illustrates the basic mono bridging method for all Hifonics

amplifiers.

Interconnect cable checklist:

A MONO signal source is required, such as would be available from the mono

sub bass output of an active crossover, whether stand alone, or built into a head

unit or equalizer. Important: Do not be tempted to connect the hot, or positive

outputs, from any source together to obtain a mono signal, as this could very

well damage the output stage of that source.

It is necessary to feed the SAME signal to both left and right inputs via a Y-

adapter RCA cable. Connect the mono speaker positive terminal to the LEFT +,

and its negative terminal to RIGHT -.

FULL RANGE

MONO LINE INPUT

VIA Y-ADAPTER

FROM MONO SOURCE

4. Line Level:

Refer to the section "Setting up systems after installation for best performance"

NOTE: Minimum final loudspeaker impedances:

4 & 2 Ohms stereo mode or 4-Ohms mono mode

This amplifier will not do 1 Ohm stereo or 2/1 Ohm mono operation.

Switch setting checklist:

- The AMPLIFIER X-OVER switch should be in the LP/BP position.

Crossover frequency control setting checklist:

LPF: 11 o'clock

Minimum final loudspeaker impedance:

- 4 ohm mono.

FULL RANGE

SPEAKERS

TO BATTERY +12v

VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND

MONO SPEAKER

or SUBWOOFER

TO BATTERY +12v

VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND