Galanz DUK002W Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Galanz DUK002W. Galanz DUK002W 12 pagina's.

Pagina afdrukken

1. Troubleshooting Guide

Care And Cleaning

Water Container Emptied

The water container collects all of the water from the condenser and must be emptied after every

drying cycle. If the water container is full, an active programme will break off automatically, the

will come on and the buzzer sounds. In order to continue the programme, the water container must

first be emptied as follows:

1.Pull out the water container.

Water-tank

3.Put the water container back into the dryer.

Humidity Sensor

In order to function correctly, the humidity sensor must be kept clean.

Please clean regularly (refer to diagram).

Cleaning The Condenser

It is important to ensure correct assembly of the condenser for effective drying and it is

recommended that you clean the condenser three or four times a year.

To clean the condenser:

1. Open condenser cover.

3.Remove the condenser rod

and run it under a tap to clean

2.Empty the water container.

4.Press the Start/Pause button

2. Release the three locking catches.

4. Reinstall as above (in reverse order).

Troubleshooting Guide

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily

without calling out an engineer. Before contacting your local Service Center, please carry out the

light

checks listed below.

During machine operation, if the appliance stops suddenly it is an indication that the machine is

not working correctly. Refer to the table below and, once the problem has been rectified, press the

Start/Pause button to restart the programme.

Malfunction

Dryer does

not work

Drying results

unsatisfactory

Drum light does

not work (option)

Drying cycle ends

shortly after

programme starts.

"END" light

illuminated.

Drying cycle lasts

an unusually long

time

If you are unable to identify or solve the problem contact our service center. Before telephoning,

make a note of the model, serial number and purchase date of your machine: the Service Center

will require this information.

IMPORTANT: If you call out an engineer to a fault listed above, or to repair a fault caused by

incorrect use or installation, a charge will be made even if the appliance is under guarantee.

Possible Cause

Solution

Mains plug is not plugged in.

Plug in at main socket.

Loading door is open.

Close loading door.

Have you pressed the

button?

Press the

Wrong programme selected.

Select a different programme the

Filter clogged.

next time you dry(see "Drying

Incorrect volume of laundry.

Programme "section).

The sediment on humidity sensor.

Clean lint filter.

Observe recommended loading

volumes.

Light bulb is defective.

Replace light bulb.

Not enough washing loaded or

Select higher drying level (e. g.

washing load is too dry for

Heavy instead of Strong)

selected programme.

Load volume is too big.

Reduce load volume.

button again.