dbRevO Wireless Tech All-in -One Design Gebruiksaanwijzing - Pagina 14

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} dbRevO Wireless Tech All-in -One Design. dbRevO Wireless Tech All-in -One Design 15 pagina's. Wireless tech all-in -one design

Pagina afdrukken

VI. Error Code

Error Code will flicker when control system is under abnormal conditions.

The console will be powered off automatically after Error Code flickers for 10

seconds.

Trouble

Trouble Description

code

No speed signal from

motor during driving.

Controller fails when

motor operates

Controller fails when

motor operates.

Torque Sensor voltage

is abnormal or out of

the scope of standard. 3. To replace Torque Sensor.

UVW wire is

E-8

disconnected when

motor operates.

Short-circuit after

E-9

motor start-up

E-A

Motor cannot operate

Controller current is

E-B

over the scope of

standard.

Battery voltage is

E-0

lower than the scope

of standard

●Users shall contact with local dealers if troubles still cannot be solved under

above situations!

Troubles And Troubleshooting

1. To check if motor signal wire is disconnected.

2. To replace motor.

1. To replace control board.

1. To check if Torque Sensor zeroing voltage setting is correct.

2. To check if Torque Sensor signal wire is disconnected.

1. To check if motor signal wire is disconnected.

2. To replace motor.

3. To replace lower controller.

1. To replace motor.

2. To replace lower controller.

1. To check if motor signal wire is disconnected.

2. To replace motor.

3. To replace lower controller.

1. To replace motor.

1. To power on the console after the battery is placed well and

switch on for 3-5 seconds.

As the console and controller are checking the battery

capacity after the battery is switched on. To power on the

console within 3-5 seconds, E-0 will flickers on the console.

2. To check if battery voltage is lower than 16V or not. If yes, to

charge the battery to full.

3. To replace console

Troubleshooting