909 909C12V Gebruiksaanwijzing - Pagina 15
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} 909 909C12V. 909 909C12V 20 pagina's. 12v variable speed oscillating multi tool
Pagina afdrukkenFollow the same basic procedure for installing carpet, using
a thicker spacer that is the same thickness of the carpet
being installed.
Cutting a hole in wood flooring
to install a heating vent
The oscillating tool can be used to cut a hole in wood
flooring for installing a heating vent.
1. Install the plunge cutting saw blade for wood in the tool.
Note:
The blade should be centred on the tool housing and
NOT installed in the 90° position.
2. Place the floor vent on the floor and use a soft lead pencil
to trace the required rectangular hole (1) on the flooring.
3. Place the saw blade (2) near the floor surface in the
middle of one of the cutting lines.
4. Set the tool speed at a medium speed and turn the tool ON.
Note:
The tool and blade should be at a 45° angle to the
floor to allow the corner of the blade to plunge cut into the
flooring.
5. While holding the tool
tightly, slowly plunge
the corner of the
blade into the flooring
until it cuts through
the flooring. Once
the plunge cut is
complete, set the tool
to its highest speed
and complete the cut
to the corner of the
rectangle.
6. Turn the saw OFF,
remove it from the cut
and proceed to cut in
the opposite direction
to complete the cut
for the first side of the
rectangle.
7. Repeat steps #4, #5 & #6 to cut the remaining three
sides of the rectangle.
8. When all cuts are complete, use a flat blade screw driver
to carefully pry the cut-out from the floor.
Note:
Do NOT use the saw blade to pry the cut-out from
the floor. You will break the blade. If the cut-out is not easy
to pry from the floor, check to make sure each line is cut
completely into the corner of the rectangle.
Cutting a hole in plasterboard for installing
an electrical outlet box
The oscillating tool can be used to cut a hole in plasterboard
for installing an electrical outlet box.
1. Install the half circle saw blade for wood & plasterboard in
the tool.
Note:
the half circle blade is not supplied in this kit but is
available under various brand names to suit this tool.
Note:
The blade should be centred on the tool housing and
NOT installed in the 90° position.
2. Place the outlet box on the plasterboard and use a soft
lead pencil to trace the
required rectangular hole (1)
on the plasterboard.
3. Place the corner edge of
the saw blade (2) near the
plasterboard in the middle of
one of the cutting lines.
4. Set the speed to the highest
speed and turn the tool ON.
5. When the tool reaches its
maximum speed, carefully
plunge the blade into the
plasterboard until it cuts
through the plasterboard.
Complete the cut to the
corner of the rectangle.
15