dBTechnologies VIO L1610 Gebruikershandleiding Snel aan de slag - Pagina 6
Blader online of download pdf Gebruikershandleiding Snel aan de slag voor {categorie_naam} dBTechnologies VIO L1610. dBTechnologies VIO L1610 7 pagina's. Symmetrical active 3-way line array with coaxial driver
Pagina afdrukken
A seventh "Bass boost" position assign particular
emphasis on the lower frequencies. The "service" one
allows USB port communication for firmware updating
(or can recall on the speaker user settings previously
saved
in
remote
control
Network). The "HIGH FREQUENCY COMPENSATION"
can act on medium-high frequencies. depending on
the distance between the line-array and the audience.
c)
Connect the power link output (9) of the first
module to the mains input (8) of a second VIO L1610
module of the line-array, and so on, in order to link
the power supply between all the elements. The
maximum linkable rated power and current depends
on the first module connection (type of cable, type of
connector used.
d)
In case of remote control, connect the proper
Data Input (3) of the first module of the line-array to
the hardware remote controller (RDNet Control 2 or
RDNet Control 8) with cables equipped with etherCON
connectors. Then connect the Data Output (3) of the
first module to the Data Input (3) of the second one,
and so on. When the RDNet network is on and it has
recognized the connected device, the LED "Link" (6) is
on. The other LED (6) "Active" start blinking when
there is the presence of data transmission, the
"Remote Preset Active" advise that all the local
controls set on the amplifier panel (level, DSP presets,
etc.) are by-passed and controlled remotely by RDNet.
See also RDNet Control 2 and RDNet Control 8 user
manuals for further information.
e)
Connect the power supply (8) to the first
module. The related "Ready" LED (5) turns on,
signaling the proper power connection. The "Signal"
LED (5) start blinking at the presence of audio signal
(greater
than
-20dBu).
conditions, potentially signaled by the "Limiter" LED
(5).
VIO L1610
www.dbtechnologies.com
with
dBTechnologies
Avoid
audio
distortion
5) Software (dBTechnologies Aurora)
VIO L1610 can be fully remote controlled via RDNet.
The connection details have been illustrated in the
chapter 4 ("d" point). In remote control mode, the use
of
free
professional
dBTechnologies,
management: dBTechnologies AURORA NET.
a) dBTechnologies Aurora NET
The software which must be used in case of remote
control is dBTechnologies AURORA NET. This software
can
control
different
configurations.
It allows a complete remote control and a full real-time
monitoring in various scenarios. For example, the user
can control a setup with 2 line-arrays of VIO L1610 and
3 VIO S318 subwoofers, and change different
parameters while the entire system is sounding.
It can also offer a deeper loudspeaker control than the
simple rear amplifier panel rotaries.
It can be downloaded for free from the official site:
www.dbtechnologies.com/EN/Downloads.aspx
Check always for software updates!
6
info@dbtechnologies‐aeb.com
software,
developed
allows
a
complete
speakers
in
420120324Q REV.1.0
by
system
different