909 HG2000 Gebruiksaanwijzing - Pagina 10
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} 909 HG2000. 909 HG2000 14 pagina's. 2000w heat gun
Pagina afdrukken5. Select the air flow by pressing the top centre button to
increase the fan speed, or the lower centre button to
reduce the fan speed. In total, there are 5 speed settings
for the fan.
6. To stop the heat gun, slide the selector switch to Off (O).
Fitting the accessories on the heat gun
•
An accessory that falls
off the heat gun while in
use can set an object on
fire. Accessories must
be mounted firmly and
securely on the unit.
•
Touching a hot
accessory or nozzle can
lead to serious burns.
Before attaching or replacing a nozzle or accessory,
either allow the unit to cool down completely or use a
suitable tool to grasp the accessory.
•
A hot nozzle can set a surface on fire. Place down hot
nozzles only on fire-proof surfaces.
•
An incorrect or defective nozzle can lead to heat
accumulation and damage the heat gun. Use only
original nozzles that are suitable for this heat gun.
Using the heat gun on its stand
The rear of the body of the heat
gun, and the rear of the lower
section of its handle, are designed
to be used as a standing base.
When in use the nozzle of the
heat gun points vertically upward.
For stationary type operation it is
suggested to use in this position.
Furthermore, for the cool down
process, it is again suggested to use this position.
When the heat gun is placed down during breaks in the
heating operation, the heat gun should always be placed on
its stand, and NOT laying on its side or nose down.
To operate the heat gun on its stand, select the desired heat
setting and fan setting. Turn the heat gun on its end so it
sits on the rear of the housing.
NOTE: Ensure the air intake vents are clear of debris and
the air intake is not restricted.
When using the heatgun on its stand on a bench or similar
raised surface, ensure the cable is well supported and does
not drag the heat gun or cause it to topple over.
Cool down procedure
After using the heat gun on setting II, the element and
nozzle are extremely hot.
The heat gun should never be turned off from setting II and
left to cool on its own unless the heat gun is shut down in
an emergency.
The following suggested cool down procedure is provided to
extend the life of the product.
1. After completion of the task being performed, move the
slide switch to setting I.
2. Increase the fan speed to maximum.
3. Position the heat gun on its
stand so the nozzle is pointing
upwards.
4. Operate the heat gun for a few
minutes or until the heat output
has significantly reduced.
DO NOT
store the heat gun in a
hot condition.
DO NOT
turn off the heat gun from setting II and then leave
the heat gun on its side or pointing downward.
DO NOT
subject the heat gun to rough handling.
10