909 ID182 Gebruiksaanwijzing - Pagina 17

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} 909 ID182. 909 ID182 20 pagina's. 18v impact driver/ wrench 9.5mm (3/8") socket drive 6.35mm (1/4") drive adaptor lithium-ion

1. Clamp the pieces together and drill the first hole 2/3 the
diameter of the screw. If the material is soft, drill only 2/3
the proper length. If it is hard, drill the entire length.
2. Unclamp the pieces and drill the second hole the same
diameter as the screw shank in the first or top piece of
wood.
3. If flat head screw is used, countersink the hole to make
the screw flush with the surface. Then, simply apply
even pressure when driving the screw. The screw shank
clearance hole in the first piece allows the screw head to
pull the pieces tightly together.
Running nuts and bolts
Variable speed control must be used with caution for driving
nuts and bolts with socket set attachments. The technique
is to start slowly, increasing speed as the nut or bolt runs
down. Set the nut or bolt snugly by allowing the impacts to
tighten the fastener over a period of time. ie the longer the
impacts, the tighter the fastener.
Note.
Hold the impact driver firmly.

Maintenance

Store the tools, instruction manual and where necessary
the accessories in the original packaging. In this way
you will always have all the information and parts ready
to hand.
Do not throw used batteries into fire or water. There
is a danger of explosion! Please hand in non-working
or used batteries, or tools with built-in batteries, to the
environmentally-safe disposal unit at a municipal waste-
disposal centre, or to your dealer.
If the cordset of the charger is damaged or worn, have it
repaired or replaced by an authorised service centre.
17