909 254CMS Gebruiksaanwijzing - Pagina 13

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} 909 254CMS. 909 254CMS 19 pagina's. 1800w 255mm (10") single bevel laser guided compound mitre saw

Pagina afdrukken

Setting the table square with the blade

1. Make sure that the electrical plug is removed from the

power point.

2. Push the saw arm (1) down to its lowest position and

engage the release knob (2) to hold the saw arm in the

transport position.

3. Loosen the mitre table lock

(15) (Fig. S).

4. Rotate the mitre table

(12) until the pointer is

positioned at 0º.

5. Tighten the mitre table lock

(15).

6. Loosen the bevel lock (7)

and set the saw arm (1)

at 0º bevel (the blade at 90º to the mitre table).

Tighten the bevel lock (7) (Fig. T).

7. Place a set square against the mitre table (12) and the

flat part of the blade (Fig. U).

Note.

Make sure that the square contacts the flat part of the

saw blade, not the teeth.

8. Rotate the blade by hand and check the blade-to-table

alignment at several points.

9. The edge of the set square and the saw blade should

be parallel.

10. If the saw blade angles away from the set square,

adjust as follows.

11. Use a 13 mm spanner

or adjustable wrench

to loosen the lock nut

securing the 0° bevel

adjustment screw (10)

(Fig. V). Also, loosen the

bevel lock (7).

12. Adjust the 0° bevel

adjustment screw (10) with

the 6 mm hex key to bring

the saw blade into alignment

with the square (Fig. W).

13. Loosen the Phillips head

screw holding the pointer

of the bevel scale (8) and

adjust the position of the

pointer so that it accurately

indicates zero on the scale

(Fig. X). Retighten the screw.

14. Retighten the bevel lock

(7) and the lock nut

securing the 0° bevel

adjustment screw (10).

Note.

The above procedure

can also be used to check the

angle of the saw blade to the

table at 45º bevel angle to the

left. The 45° bevel adjustment

screw (9) is the side of the saw arm. You will require a 13 mm

spanner or adjustable wrench (not supplied) for the lock nut

(Fig. Y) and the 6 mm hex key for the set screws (Fig. Z).