Galaxy DX-55HP Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Galaxy DX-55HP. Galaxy DX-55HP 10 pagina's. 10-meter am/fm mobile transceiver built in frequency counter with roger beep

Pagina afdrukken

1. Control Functions

C. Check your coaxial cable routing (it may be pinched when routed

into the car).

D. Try a different location on your car (keeping in mind the radiation

pattern you wish)

Is the antenna perfectly vertical?

Try a different location in your neighborhood. Stay away from

large metal objects when adjusting (metal telephone or light posts,

fences, etc.).

NOTE

The transceiver will operate into an SWR of 2 to 1 indefinitely

and sustain an SWR of 20:1 for a maximum of 5 minutes at rated

operating conditions.

EXTERNAL SPEAKER

The external speaker jack (EXT.SPK) on the rear panel is used for

remote receiver monitoring. The external speaker should have 8 ohms

impedance and be able to handle at least 4 watts. When the external speaker

is plugged in, the internal speaker is disconnected.

- 7 -

Operation

CONTROL FUNCTIONS

There are thirteen controls and three indicators on the front panel of

your transceiver.

12 13

F.DISPLAY

OFF

R.B.

SIGNAL

OFF

POWER

VOL

MIC

DX 55HP

OFF

FRONT PANEL

1. OFF/ON/VOLUME (inner dual concentric). Turn clockwise to apply

power to the unit and to set the desired listening level. During normal

operation, the VOLUME control is used to adjust the output level

obtained either at the transceiver speaker or the external speaker, if used.

2. SQUELCH (outer dual concentric). This control is used to cut off or

eliminate receiver background noise in the absence of an incoming

signal. For maximum receiver sensitivity it is desired that the control be

adjusted only to the point where the receiver background noise or

ambient backgrounds noise is eliminated. Turn fully counterclockwise

then slowly clockwise until the receiver noise disappears. Any signal to

be received must now be slightly stronger than the average received

noise. Further clockwise rotation will increase the threshold level, which

a signal must overcome in order to be heard. Only strong signals will be

heard at a maximum clockwise setting.

3. MIC GAIN (inner dual concentric). Adjust the microphone gain in the

transmit and PA modes. This controls the gain to the extent that full talk

power is available several inches away from the microphone.

4. RF GAIN CONTROL (outer dual concentric). Use to reduce the gain

of the RF amplifier under strong signal conditions.

+10KHz

OFF

DIM

PWR

CLARIFIER

OFF

BAND

- 8 -