ADENDORFF MAC AFRIC SSANDB-002 Originele gebruiksaanwijzing - Pagina 4
Blader online of download pdf Originele gebruiksaanwijzing voor {categorie_naam} ADENDORFF MAC AFRIC SSANDB-002. ADENDORFF MAC AFRIC SSANDB-002 7 pagina's.
Pagina afdrukken
INSTRUCTIONS FOR OPERATION
Adjusting the arm inclination
CAUTION:
· Always be sure that the tool is switched off and unplugged before carrying out any
work on the tool.
The arm can be pivoted and fixed at any
desired angle within the "A" range
according to the operating position or the
figure of the workpiece.
Loosen the lock lever by raising it. Pivot
the arm to the desired position, and secure
the lock lever to fix the arm firmly. (Fig.1)
Switch action
CAUTION:
· Before plugging in the tool, always
check to see that the switch trigger
actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the trigger.
Release the trigger to stop.
For continuous operation, pull the trigger
and then push in the lock button. To stop the tool from the locked position, pull the trigger
fully then release it. (Fig.2)
Speed Adjusting
CAUTION:
· The speed control turned only as far as 6 and back to 1. Do not force it past 6 or 1,
otherwise the speed adjusting function may no longer work.
The tool speed can be changed between 5m/s and
28m/s by turning the speed control to a given
number setting from 1 to 6. (At the time when the
switch trigger is fully pulled.)
Higher speed is obtained when the speed control is
turned in the direction of number 6. And lower speed
is obtained when it is turned in the direction of
number 1. (Fig. 3)
Installing or Removing Abrasive Belt
Pull the cam lever all the way out. Install the belt
over the rear pulley, and slip the belt over the front
pulley, with the belt pulled out to the front arm.
Return the cam lever to the original position. (Fig. 4)
Adjusting Belt Tracking
Switch on the tool and make sure that the belt is
aligned properly.
Use the wing bolt to center the belt tracking. Turn
the wing bolt clockwise to incline the arm to the
right, or counterclockwise to incline it to the left.
(Fig. 5)