Galaxy Galaxy Top mount Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Galaxy Galaxy Top mount. Galaxy Galaxy Top mount 17 pagina's.
Ook voor Galaxy Galaxy Top mount: Gebruiks- en onderhoudshandleiding (16 pagina's)

Pagina afdrukken

Troubleshooting

OCCURRENCE

Beforeyou

call forsen/ice,

review this list. It may save you time and

expense.

The list includes common

occurrences that are not the result of

defective workmanship

or materials in this appliance.

POSSIBLE CAUSE/SOLUTION

Range is not level.

Poor installation. Place oven rack in center of oven. Placea level on the

oven rack. Adjust leveling legs at base of range until the rack is level. When

oven is level, cooktop may not appear to be level with countertop.

Weak, unstable floor. Be sure floor is level and can adequately support

range. Contact a carpenter to correct sagging or sloping floor.

Kitchen cabinet rnisalignment

may make range appear to be unlevel. Be

sure cabinets are square and have sufficient room for range clearance.

Cannot

move appliance

easily.

Appliance

must be accessible

for

service.

Cabinets not square or are built in too tight. Contact a cabinet maker to

correct the problem.

Contact builder or installer to make appliance accessible.

Carpeting interferes with range. Provide sufficient space so range can be

lifted over carpet.

Gas line is hard-plumbed. Have a flexible A.G.A./C.G.A. approved metal

appliance connector installed.

Surface burners do not light.

Surface Control knob has not been completely turned to LITE. Push in and

turn the Surface Control knob to LITE until burner ignites and then turn

control to desired flame size.

Burner ports are clogged, With the burner off, use a small-gauge

wire or

needle to clean ports. See 'Surface Burners' in the cleaning chart under

General Cleaning

for additional

cleaning instructions.

Range power cord is disconnected from outlet. Be sure cord is securely

plugged into the outlet.

Electric power outage. Burnerscan be lit manually. See Setting Surface

Controls in this Owners Guide.

Surface burner

flame burns half way

Burner ports are clogged. With the burner off, clean the ports with a small-

around,

gauge wire or needle.

Moisture is present after cleaning. Lightly fan the flame and allow burner to

operate until flame is full. Dry the burners thoroughly following instructions

under General Cleaning.

Surface burner

flame is orange.

Dust particles in main line. Allow the burner to operate a few minutes until

flame turns blue.

In coastal areas, a slightly orange flame is unavoidable due to salt air.

Oven does not operate.

Temperature

Control knob is not set properly. Make sure the Temperature

Control knob is set to the desired function. See Setting

Oven Controls.

Be sure regulator gas valve is "ON." See Installation Instructions.