909 H144L1 Gebruiksaanwijzing - Pagina 15

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} 909 H144L1. 909 H144L1 17 pagina's. 14.4v sds plus pneumatic action variable speed hammer drill driver

Pagina afdrukken

Screwdriving

A screwdriver attachment is supplied with the drill which

allows the easy fitment of 6mm hex driver bits.

Select the drill / screw position on the selector.

Fit the driver adaptor supplied into the SDS Plus holder of

the drill.

Fit the required driver piece into the adaptor for the task to

be undertaken.

(Note:

Driver bits are not supplied with the

H144L1 kit)

When applying or removing screws, always wear safety

glasses.

Locate the driver bit into the head of the screw. Select

forward or reverse, depending on the operation to be

performed. Slowly depress the trigger while at the same

time applying pressure on the drill to maintain the driver bit

in the head of the screw.

Where possible, start the screwdriving operation under

variable speed and use full speed while the operation is

under way.

Note:

There is NO clutch on the output of the drill so

practice seating screws to the correct depth on a scrap

piece of timber first.

Warning:

Ensure the correct driver bit is selected for the

screw being fitted or removed.

Drill safety features

Drill overload

This drill is fitted with an overload protection. If the drill is

excessively forced, or the task being performed is too great

for the drill, the drill will automatically go into an overload

mode. When the drill goes into overload, the drill will

automatically and suddenly STOP. To reset the overload,

simply release the trigger. When the trigger is pressed

again, the drill will restart. Resume work after the overload

has been reset, but reduce the load by using a smaller drill

bit or re-sharpen the existing drill bit and reduce the amount

of force placed on the drill.

CAUTION.

Do not continue to overload the drill and

constantly reset the overload. Doing this will cause the

battery cells to overheat.

Temperature cut out

If the drill is constantly overloaded, or the drill is used

constantly at maximum rating in high ambient conditions,

the battery cells may overheat, causing the battery pack

to shut down.

When this occurs you will need to immediately stop drilling

and allow the battery cells to reduce the temperature.

To reduce the temperature of the cells, remove the battery

pack from the drill and place the battery pack in a free-air

environment, out of direct sunlight and any other heat

source.

DO NOT force cool the pack in any way. Do not place in

a refrigerator or freezer.

When the battery pack has cooled down it can again

be used to operate the drill, as long as the load or the

conditions causing the original excessive temperature

has been corrected.