909 HD1050 Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} 909 HD1050. 909 HD1050 13 pagina's. 909 hd1050; hd850 high performance hammer action drill

Pagina afdrukken

Operation

Starting and stopping

Operational controls

1. Ensure that the tool is in

good condition.

2. Plug the cordset into the

mains socket.

3. Depress the trigger switch (7)

to start the drill and release the

trigger when you wish to stop.

4. Press the lock-on button (5)

whilst the trigger is depressed

if you require continuous

operation. To disengage the

lock-on switch, press the trigger

then release it.

Variable speed trigger switch

You can adjust the speed of the drill between zero and

maximum by varying the pressure on the trigger. The harder

you press on the trigger the faster the drill

will operate.

Speed adjustment

You can change the maximum

speed setting by turning the speed

dial (8) located on the trigger switch

(7). To increase the speed turn

the dial so that the thickest part of

the line is above the arrow on the

trigger, as shown in Fig. 1.

Fig. 1

Reversing the direction

of rotation

1. The forward/reverse switch (6)

protrudes from one side of the

drill to the other.

2. The arrow head symbol on each

side of the switch indicates the

direction of drilling when the

switch is pushed from that side.

The forward direction is selected

when the arrow head symbol

points to the front of the drill. The

reverse direction is selected when

the arrow head symbol points to

the rear of the drill.

CAUTION.

Any attempt to reverse

the direction of rotation whilst the drill is turning

is likely to permanently damage the motor, gearing

or both.

Drilling/hammer mode selector

You can use the drill for both

hammer action and normal drilling.

1. Use the drilling/hammer mode

selector (4) to select hammer or

drill action. The type of drilling

selected is indicated

by the symbol on each side of

the drill.

2. Push the selector to

hammer action.

3. Push the selector to

action.

CAUTION.

Change the mode of

action only when the drill has come

to a complete standstill.

Note.

Hammer action drilling should only be preformed

in the forward direction.

for

for drill