Galaxy 3500M Installatie- en gebruikershandleiding - Pagina 10
Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} Galaxy 3500M. Galaxy 3500M 17 pagina's.
Pagina afdrukken
It is recommended that the shower unit and
accessories be cleaned using a soft cloth and
that the use of abrasive or solvent based
cleaning fluid be avoided, especially on any
plated finishes.
We recommend that before any cleaning, the
isolating switch be turned off, thus avoiding
accidentally switching on the shower.
All water contains particles of lime-scale, which
build up in the shower handset and unit reducing
the performance.
It is therefore important to clean the shower
handset by simply rubbing the rubber
nozzles, or soaking in a proprietary lime-scale
remover and rinsing thoroughly before use.
NOTE:
After use it is normal for some water to drip from
the shower handset for a few moments.
This inhibits lime-scale build-up over prolonged
use.
WARNING:
YOU MUST REGULARLY INSPECT
THE SHOWER HOSE FOR WEAR
AND DAMAGE AND REPLACE IF
NECESSARY, OR EVERY 2 YEARS,
WITH OUR APPROVED PART.
WARNING:
IN ORDER TO MAINTAIN THE
PERFORMANCE OF YOUR SHOWER,
YOU MUST CLEAN THE SHOWER
HANDSET REGULARLY.
CLEANING THE FILTER
The filter can be cleaned in order to maintain the
performance of the shower if required.
It is essential that this operation is carried out by
a competent person.
WARNING!
SWITCH OFF THE ELECTRICITY AT
THE ISOLATING SWITCH AND THE
WATER SUPPLY AT THE MAINS
BEFORE REMOVING THE FRONT
COVER.
The inlet filter is situated inside the water inlet
fitting (fig.15).
To gain access to the filter remove the front
cover and backplate lower section.
Unscrew the filter cap on the water inlet fitting
(fig.14).
Remove the filter cap and flush with clean water
and then replace.
When cleaning the filter, DO NOT use a sharp
object, as it will cause damage.
It is preferable to use an old toothbrush or
similar
The metal filter mesh is best to be cleaned when
it is in the cap as shown.
Refit the filter cap then secure with 5 screws.
Refit the lower section and front cover.
Take care to re-position the filter correctly.
10
14