DYNAPAR SLIM Tach SL85 Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DYNAPAR SLIM Tach SL85. DYNAPAR SLIM Tach SL85 14 pagina's. Magnetoresistive encoder, designed for use in 0.625" to 3.000" 16mm to 76mm, shaft diameters
Pagina afdrukken2.1.1 Encoder Frame Installation
To install the encoder frame, perform the following steps.
1. Orient the encoder frame so the 8.5 inch I.D. surface will fit over the 8.5 inch C flange (encapsulated side toward the
motor). Mount frame onto the motor flange. Insert the four 1/2 inch x 13 UNC socket head cap screws through the
frame and into the motor frame. Use a 3/8 inch hex wrench to tighten a nominal 25 foot pounds. See Figure 3.
On End-of-Shaft units, one may wish to mount the encoder frame after mounting the
pulse wheel. See page 10.
7
NorthStar SLIM Tach
®
NOTE
Figure 3: Typical Motor Mounting
DYNAPAR
©
SL85 Instruction Manual
+1.800.873.8731