DYNAPAR NorthStar RIM Tach 1250 Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DYNAPAR NorthStar RIM Tach 1250. DYNAPAR NorthStar RIM Tach 1250 14 pagina's. Digital tachometer

Pagina afdrukken

1.0 Safety Summary

High current, voltage, and rotating parts can cause serious or fatal injury. The use of electric machinery, like all other uses of

concentrated power and rotating equipment, may be hazardous. Installing, operating, and maintaining electric machinery

should be performed by qualified personnel, in accordance with applicable provisions of the National Electrical Code and

sound local practices. Failure to comply with these precautions or with specific warnings elsewhere in this manual violates

safety standards of design, manufacture, and intended use of the instrument. Dynapar assumes no liability for the customer's

failure to comply with these requirements.

Rotating Machinery

Avoid contact with rotating parts. Avoid by-passing or rendering inoperative any safety guards or protection devices. Avoid

extended exposure in close proximity to machinery with high noise levels. Use proper care and procedures in handling,

lifting, installing, operating and maintaining the equipment.

Before Installation

Safe maintenance practices with qualified personnel is imperative. Before starting maintenance procedures, be positive that,

(1) equipment connected to the shaft will not cause mechanical rotation, (2) main machine windings have been disconnected

and secured from all electrical power sources, and (3) all accessory devices associates with the work area have been de-

energized. If high potential insulation test is required, follow procedures and precautions outlined in NEMA standards MG-1.

Grounding

Improperly grounding the frame of the machine can cause serious or fatal injury to personnel. Grounding of the machine

frame and structure should comply with the National Electrical Code and with sound local practices. Check wiring diagram

before connecting power.

Do Not Operate In An Explosive Atmosphere

Do not operate the instrument in the presence of flammable gases or fumes. Operating any electrical instrument in such an

environment constitutes a definite safety hazard.

Keep Away From Live Circuits

Operating personnel must not remove instrument covers. Component replacement and internal adjustments must be made by

qualified maintenance personnel. Do not replace components with power cable connected. To avoid injuries, always

disconnect power and discharge circuits before touching them.

Do Not Substitute Parts Or Modify Instrument

Do not install substitute parts or perform any unauthorized modification to the instrument. Introducing additional hazards is

dangerous. Return the instrument to an authorized Dynapar representative for service and repair to ensure that safety features

are maintained.

CAUTION!: Crucial information that must be read and followed regarding product functioning and

safety.

DO THIS!: Additional procedure that must be read and followed for proper operation, without safety

concerns.

NOTE: Useful information.

QUESTION: Helpful hints to answer your possible questions.

NorthStar RIM Tach

1250 Instruction Manual

CHAPTER 1

INTRODUCTION

Dynapar (847) 662-2666

17 November 2008