Galaxy Audio Any Spot AS1000 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Galaxy Audio Any Spot AS1000. Galaxy Audio Any Spot AS1000 20 pagina's. Wireless in ear monitor

Pagina afdrukken

AS1000

AS-1000 System Set-up and Operation

1. Attach the UHF antenna to the TNC connector on the rear

panel of the transmitter.

2. Check the voltage of the included AC adapter, and make

sure it conforms to the line voltage available in your local

area. Using the wrong AC adapter may cause irreparable

damage to the unit.

3. Plug the feeder cable of the AC adapter into the DC IN jack

on the transmitter. Then plug the AC adapter into a power

outlet. Switch on the power button on the transmitter.

4. Using the Group and Channel rotary switches, select a

frequency program number that is not already in use by

another wireless unit.

5. Connect the audio source(s) to the transmitter. For Mic level

signals use the XLR (MIC) input jack. For Mono Line level

signals use the ¼" (MIC) input jack. For Stereo Line level

signals use the Stereo RCA jacks. (The RCA jacks may also

be used in Mono by sliding the Stereo/Mono switch to Mono

mode).

6. Turn all volume controls on the transmitter to minimum.

Send audio signals from the source(s) at the approximate

level that will be used during the performance. Sources may

be a monitor mix from a mixing console, a CD player, or even

a single microphone.

7. Starting at minimum, slowly turn up the MIC volume control

until the transmitter Peak LED starts to light. Then turn the

control back down just enough to keep the LED from lighting.

Repeat this procedure for the LINE IN volume control (if used).

These levels will be a good starting point and provide a good

signal to noise ratio while avoiding distortion.

8. If desired, the audio may be monitored at the transmitter

location by plugging in headphones to the ¼" headphone jack.

Adjust PHONES to set the volume.

9. Open the battery door on the AS-1000R receiver and install

two AA batteries.

10. Adjust the Group (GR) and Channel (CH) rotary switches

to match the frequency number selected on the transmitter.

SYSTEM SETUP & OPERATION