dynarex 10372 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} dynarex 10372. dynarex 10372 2 pagina's.

Pagina afdrukken

ASSEMBLY INSTRUCTIONS

AND PRECAUTIONS

1. Unfold the sides of the commode frame and stand upright.

2. Attach front cross brace by depressing brass push pins and

sliding brace into side frame socket. Repeat on the other

side. Be sure brass push pins "snap" through holes.

3. Attach back brace by depressing brass push pins and

sliding back brace into receptacle located on back of cross

brace. Be sure brass push pins "snap" through holes.

4. Lower commode bucket or splash guard into bracket.

5. Attach seat and lid onto back of frame.

Front Cross

Brace

Side

Frame

Socket

Commode

Bucket

1. Before use, adjust height of each leg to your specific needs,

making sure all legs are at the same height. When desired

height is reached, lock legs into place by aligning buttons into

proper holes (see Figure 1).

2. Be sure legs are locked into place by pushing down on or by

pulling legs.

1. DO NOT use commode without first reading and

understanding this assembly and instruction sheet. If you

can not understand these instructions, contact a healthcare

dealer or technical professional before attempting to install.

Otherwise, injury or damage may occur.

Push Pins

2. Make certain that the height adjusting snap buttons fully

protrude through the respective hole.

Side

3. Ensure that all components of the commode are secure

Frame

and locked in place.

4. Check the rubber tips on the legs for rips, wear or if they

are missing. Immediately replace any or all if any

imperfections exist.

5. All four leg extensions with rubber tips MUST be level to

Back

the floor.

Brace

6. Users with limited physical strength should be supervised

or assisted while using commode.

Commode

Lid

ADDITIONAL LEG HEIGHT

FIGURE 1

WARNING