HIGH FORMAT BELVEDERE Handleiding voor snelle installatie

Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} HIGH FORMAT BELVEDERE. HIGH FORMAT BELVEDERE 2 pagina's.

Your safety is important to us. When appropriate, please follow OSHA guidelines and utilize safety

toe boots, hard hats and gloves, as well as eye, ear, and respiratory protection.

For more detailed information on the Belvedere® Fire Pit, visit our Technical Guide at www.

highformat.com or contact HIGH FORMAT® technical support.

TOOLS AND SUPPLIES

Required:

Level

INSTALLATION TIPS

•

Patio Top Installation: Fire pits should never be installed atop a patio surface. Rather, the fire

pit should be "cut in" to the patio surface to avoid damage to the patio.

•

Setting the Proper Circumference: Place the steel liner, lip-side down, at the point of

installation. Build the base layer around this liner to approximate proper circumference. Adjust

the circumference as necessary. Remember to flip the steel liner, lip-side up, after completing

the first row of block.

•

Pattern: Follow the attached block layout pattern to build the fire pit.

•

Securing the Coping: Adhere the coping to the top row of block with landscape adhesive.

•

Ventilation Clearance: On the finished fire pit, the steel liner should rest approximately ¼" below

the coping. This will allow for proper heat dispersal, extending the life of your fire pit.

INSTALLATION NOTES

1. Familiarize yourself with the construction details shown in this document.

2. Mark out the location for your fire pit. Note dimensions shown are nominal so mark an area

slightly larger than shown.

3. Excavate for drain stone base (approx. 6")

4. Fill excavated area with drain stone, level, and compact.

5. Place and center steel ring on prepared base.

6. Place blocks per the pattern. (For Round Kit, keep Blocks 1 1/2" off steel ring)

7. WARNING! Do not place the fire pit directly atop a patio surface. Instead, the fire pit should be

"cut in" to the patio surface to avoid damage to the patio caused by conductive heat transfer.

8. After placing blocks around the ring, adjust the blocks in or out to make the circle close and fit

tight. If the blocks do not close the circle, move all blocks slightly in. If the blocks seem too long,

move the blocks slightly out.

9. Place caps in circle around fire pit. Adjust the caps in or out to make them fit tightly together.

10. Note: Not suitable for large fires. Fire size should not allow flame to contact Caps on Round

Fire Pit.

Gas conversion kits are available.

Tape Measure

H I G H F O R M AT.C O M

( 8 7 7 ) 7 7 7 - 6 5 5 8

QUICK INSTALL GUIDE

BELVEDERE® FIRE PIT

Landscape Adhesive