DCA S1P-FF03-180 Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DCA S1P-FF03-180. DCA S1P-FF03-180 8 pagina's.

Pagina afdrukken

11.

Ventilate your work area adequately when you perform sanding operations.

12. Use of this tool to sand some products, paints and wood could expose user to

dust containing hazardous substances. Use appropriate respiratory

protection.

13. Pay attention that the wheel continues to rotate after the tool is switched off.

14. Do not touch the workpiece immediately after operation; it may be extremely

hot and could burn your skin.

SAVE THESE INSTRUCTIONS.

WARNING! MISUSE or failure to follow the safety rules stated in this

instruction manual may cause serious personal injury.

INSTRUCTIONS FOR OPERATION

Installing or Removing Abrasive Disc

CAUTION:

Always be sure that the tool is

switched off and unplugged before

installing or removing the disc.

Mount the rubber pad onto the spindle.

Fit the abrasive disc on the rubber pad

and screw the lock nut onto the

spindle.

To tighten the lock nut, fix the spindle by accessorial wrench, then use the lock nut

wrench and securely tighten clockwise. (Fig. 1)

To remove the abrasive disc, follow the installation procedure in reverse.

-5-

Installing or Removing the Wool Bonnet

To install the wool bonnet, first remove the dirt on the rubber pad. Then fix the spindle

with accessory wrench and tighten the abrasive disc on the spindle.

Install the wool bonnet onto the rubber pad.

When removing the wool bonnet, pull it from the

rubber pad, then fix the spindle with accessory

wrench, and loosen the rubber pad. (Fig. 2)

CAUTION:

Be sure that the tool is switched off and

unplugged when installing or removing the

rubber pad.

Switch Action

To start the tool, simply pull the switch trigger.

Release the trigger to stop.

For continuous operation, pull the trigger and

then push in the lock button. To stop the tool

from the locked position, pull the trigger fully and

then release it. (Fig. 3)

CAUTION:

Before plugging in the tool, always check to see

that the tool is switched off.

Speed Adjusting Dial

The tool speed can be changed between 2500 rpm and 3400 rpm by turning the

speed adjusting dial to a given number setting from 1 to 6. (At the time when the

switch trigger is fully pulled.)

-6-