Dynascan PMR446 Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dynascan PMR446. Dynascan PMR446 11 pagina's. Handheld transceiver
Ook voor Dynascan PMR446: Gebruiksaanwijzing (16 pagina's), Gebruiksaanwijzing (10 pagina's)

Pagina afdrukken
Dynascan PMR446 Gebruiksaanwijzing
i.

CHANNELS AND FREQUENCIES

11. TROUBLESHOOTING

PROBLEM
The radio will not turn on
The battery pack only lasts a short time after charging.
The radio will not scan.
Background noise is heard continuously.
Nothing can be heard when using an external headset.
The radio will not communicate with other members of the
group.
The communication received is not continuous.
The signal received is distorted.
The radio will not transmit.
The LED indicator light is green but no communication can be
heard.
If you have carried out the advice shown above and continue to experience problems with your radio, please consult with your
reseller or technical services.
CHANNEL (CH)
1
2
3
4
5
6
7
8
11
FREQUENCY (MHz)
446.00625
446.01875
446.03125
446.04375
446.05625
446.06875
446.08125
446.09375
POSSIBLE CAUSE/SOLUTION
-
The battery pack may have run out of charge.
Recharge or replace the battery pack.
-
The battery pack may not be inserted correctly.
Remove the battery pack and re-insert it.
-
The [
] key is damaged. Consult with technical
services for repair.
-
The life of the battery pack has been exhausted.
Replace the battery pack with a new one that has the
same characteristics as those of the battery pack
supplied with the radio.
-
The life of the battery pack has been exhausted.
Replace the battery pack with a new one that has the
same characteristics as those of the battery pack
supplied with the radio.
-
The squelch is open. Re-set the squelch level.
-
Adjust the squelch to an appropriate level.
-
The headset connector may be damaged. Consult with
your reseller of technical services for repair.
-
Ensure that you have selected the same channel and
QT/DQT as the other members of the group.
-
You may be out of communication range.
-
You may be out of range or in an area with bad radio
signal.
-
The radio's internal speaker may be damaged. Consult
with your reseller or technical services for repair.
-
It is not possible to transmit when the channel is busy
and you have activated the 'Busy Channel Lockout'
function.
-
The volume level is set too low. Increase the volume
level.
-
The QT/DQT signalling must be programmed to the
same signalling as the other members of the group.
Set the same signalling.
-
The radio headphone jack is damaged. Consult with
your reseller or technical services for repair.