9dot SPI Handmatig - Pagina 13

Blader online of download pdf Handmatig voor {categorie_naam} 9dot SPI. 9dot SPI 15 pagina's.

SPI Output power supply

The main function of the PoE injector of this device is to allow the powering of other equipment on the network. SPI PoE

injector modules are passive injectors.

IMPORTANT NOTE: Unlike active PoE, passive PoE does not use any protocol to determine the type of device to be powered;

it simply applies a type of voltage to its port without identifying which type of PoE standard or supply voltage the connected

load is compatible with. Using an unsuitable voltage and / or wrong pin out can cause irreparable damage to the powered

device.

It is possible to power a wide range of devices that accept different voltages as this module essentially replicates the voltage

from the power terminals to the PoE output ports without applying any conversion.

This offers great versatility when it comes to connecting several PoE devices in the same infrastructure as each module can be

powered with a different voltage than the rest.

In addition to supporting different voltages, the SPI has the ability to select the pin out of the PoE output ports, with two

selectors placed on the side of the module, thus allowing it to power a wide range of devices on the market.

To find out if your PoE device can be powered by SPI, just check the pin out that the switches allow you to select and see if it

matches the input pin out of your equipment

Selectors

With the mode and polarity selectors of the SPI module it is possible to select the output pin out of the PoE port, according to

the following tables:

Special case -48V

There are installations that require -48V mains power supply, this option is perfectly feasible with SPI. We simply have to

connect the -48V to the SPI input

on the input pin out of the devices we want to connect.

Protection

On the PoE port there are double phase surge arresters TVS (Transient Voltage Suppression) and GDT (Gas Discharge Tube).

See the sections "Selectors"

As explained in the "Input power supply" section

SPI & SPP MANUAL

Modality

MODE A+B

MODE B

MODE A

Table 4 - SPI selectable mode types

Polarity

NORMALE

+ 4,5 and/or 1,2 | – 7,8 and/or 3,6

INVERSA

– 4,5 and/or 1,2 | + 7,8 and/or 3,6

Table 5 - SPI selectable polarity types

and then select the correct mode and polarity in order to get -48V on the PoE ports based

Pins

Po4P

4,5 / 7,8

1,2 / 3,6

Pins

VER. 2 REV. 0