Autopage RS-601 Bedieningshandleiding - Pagina 5

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Autopage RS-601. Autopage RS-601 9 pagina's. Professional remote car starter with remote entry operation

Pagina afdrukken

1. Return to normal operation, turn ignition 'on'.

2. Push and hold valet switch for 2 seconds, The LED will turn off

indicating the system has exited the valet mode.

IGNITION CONTROL DOOR LOCKS.

If the vehicle's door locks have been interfaced to the security system,

the system will automatically lock the vehicle's doors when the ignition

is turned "ON" and /or unlock the vehicle's doors when the ignition is

turned "OFF".

TRUNK RELEASE (Additional Installation Required)

Press and hold the

to remote control the trunk release or other electric devices.

WARNINGS:

As with any product that performs automatic functions, there are certain

safety precautions that you must practice and be aware of.

1. Keep the transmitter out of children's reach.

2. Do not leave anyone in the vehicle while running on remote control.

3. Alert servicing personnel that the vehicle can be started automatically.

4. Do not start the vehicle by remote while it's in an enclosed area or

garage.

5. Always apply the parking brake and lock the v ehicle as you exit the

vehicle.

6. Should the unit malfunction, disconnect the fuse until the problem is

corrected.

7. The use and operations of this system is the sole responsibility of the

operator.

8. Some areas may have local ordinances that prohibit leaving a vehicle

running on public streets.

A. TO REMOTE START THE VEHICLE:

When you want to start your vehicle,

1. Press

2. The parking lights will flash to indicate the remote start received the

signal.

3. The engine will start in approximately 5 seconds.

4. Once the engine is running, after a couple of seconds the parking light

will turn on again and climate controls will activate and adjust the

vehicles interior temperature to your preset setting.

5. The vehicle will run for 5 to 30 minute cycle and automatically shut

down. The duration of the starting mode is programmable.

buttons on transmitter for three seconds

REMOTE START OPERATION:

button TWICE on either remote transmitter.