Dynatech QUASAR Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dynatech QUASAR. Dynatech QUASAR 14 pagina's. Overspeed governor

INSTRUCTIONS: QUASAR Cod: DYN 48.1.07

Fecha: 04/12/2017 Revisión: 07

4 WORKING PRINCIPLES.

The governor is of the centrifugal type, and can be unidirectional or bidirectional.

The ropes which can be used for this governor are:

Rope of 6.5 mm Gustav Wolf PAWO 819W

Rope of 6 and 6,5 mm Drako 250 T

The governor is directly anchored to the slab in the

machine room or to the upper part of the lift shaft, linked

to its tensioning pulley in the pit via the rope.

The rope runs along the governor and the tensioning

pulley's groove.

The ends of the rope are fixed to the driving bar's cable

ties. This way, when the car reaches the tripping speed,

the movement concerning the governor rope will cause

it to lock.

The working diagram is as follows:

(1) QUASAR governor

(2) Governor's rope

(3) Tensioning Pulley

As previously mentioned, the governor is anchored to the slab, either in the machine room or at the upper part of the

lift's shaft.

The ends of the rope (2) are fastened to the governor's attachment (1) of the driving bar by using thimbles and cable

clips.

Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer

area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/

Where:

(1) - Main pulley

(2) - Centrifugal system

(3) - Locking system

(4) – Governor's fixing