Galiso HDD-8RB Installatie-/gebruikshandleiding - Pagina 9

Blader online of download pdf Installatie-/gebruikshandleiding voor {categorie_naam} Galiso HDD-8RB. Galiso HDD-8RB 14 pagina's. With digital control
Ook voor Galiso HDD-8RB: Gebruiksaanwijzing (12 pagina's)

Pagina afdrukken

5.0 OPERATION, continued

G. The Operation Indicator will flash green while in operation.

H. Zone Indicator will always display 1. Only one zone has been programmed for

this Controller.

I. The Reset Button

NOTE: An Over-temperature monitor has been installed to prevent this system from

overheating. If temperatures are over reached, the system will shut off the Heater and

an error message will be shown. Pressing Reset

temperature has not exceeded the target pressure.

J. The following Buttons are only used for programming purposes;

any problems or programming questions, please contact Galiso

854-3789.

K. After cylinders have been drying for a short time (5-10 minutes), check each

cylinder for dryness, and replace on the dryer if necessary or, load the next

cylinder.

NOTE: Cylinder dry times can vary, depending on the size and/or material. Galiso, Inc.

recommends using low temperature settings for composite cylinders.

The dryer can remain "On" when changing out cylinders but the

operator should be careful to avoid touching the Manifold Frame,

as it may be hot. Also, Always wear Insulated Gloves when

removing the Probes.

L. To shut down at the end of the day, flip the Power Switch to the "OFF" position.

6.0 MAINTENANCE

A. No regular maintenance is required except to check the air filter on top of the

muffler at least once a month and replace if needed.

Section 5 – 2

will only be used if over-temperature has been reached.

! CAUTION !

will restart operation, if the

E Z

, Inc. At 1-800-

21-11-1025

. For