Gallagher C300421 Installatie Opmerking - Pagina 4
Blader online of download pdf Installatie Opmerking voor {categorie_naam} Gallagher C300421. Gallagher C300421 13 pagina's.
Ook voor Gallagher C300421: Handmatig (12 pagina's)
Pagina afdrukken
1
Introduction
The Gallagher T12 Reader is a mobile credential and smart card proximity reader. It can be installed as
either an entry reader or exit reader. It can be mounted on a BS 4662 British Standard square flush box.
The reader sends information to the Gallagher Controller and acts upon information sent from the
Gallagher Controller. The reader itself does not make any access decisions.
The reader is available in four variants. The card technologies for each variant are shown below.
Reader
T12 Mifare Reader Black
T12 Mifare Reader White
T12 Multi Tech Reader Black
T12 Multi Tech Reader White
The reader can be connected as an HBUS Reader or Cardax IV Reader. An HBUS Reader uses the HBUS
communications protocol to communicate with the Gallagher Controller. A Cardax IV Reader uses the
Cardax IV Reader communications protocol to communicate with the Gallagher Controller.
IMPORTANT: HBUS compatibility
HBUS communications are supported with sites running Gallagher Command Centre vEL7.00 software
(or later).
IMPORTANT: Multi Tech readers
Using dual technology 125/Mifare cards with Gallagher Multi Tech readers may cause both card
technologies to be read, resulting in double card badges and unusual reader feedback. Gallagher
strongly recommends against using dual technology 125/Mifare cards with Multi Tech readers for sites
running pre-Command Centre v7.00 software. From Command Centre v7.00, a site may specify which
technology a Multi Tech reader should read off a dual technology card.
IMPORTANT: Mobile credential readers
Gallagher Multi Tech readers support Gallagher mobile credentials using Bluetooth® wireless
technology. Mobile credentials are supported with sites running Gallagher Command Centre vEL7.60
software (or later). To use mobile credentials, the Multi Tech reader must be connected as an HBUS
Reader.
2
Before you begin
2.1
Shipment contents
Check the shipment contains the following items:
•
1 x Gallagher T12 Reader facia assembly
•
1 x Gallagher T12 Reader bezel
•
1 x M3 Torx Post Security screw
•
2 x M3.5 Phillips drive fixing screws
•
4 x 25 mm No.6 self tapping, pan head, Phillips drive fixing screws
•
4 x 40 mm No.6 self tapping, pan head, Phillips drive fixing screws
3E4290 Gallagher T12 Reader | Edition 1 | August 2016
Copyright © Gallagher Group Limited
Product codes
Supported card technologies
C300420
Mifare DESFire EV1, Mifare Plus and
C300421
Mifare Classic
C300440
Mifare DESFire EV1, Mifare Plus, Mifare
C300441
Classic and 125 KHz cards
Page 4