Adept Audio IC62TT Installatiehandleiding - Pagina 7

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Adept Audio IC62TT. Adept Audio IC62TT 12 pagina's.

Ceiling Speaker Installation Manual
Installing the speaker in the bezel ring
Once the speaker cable connections are made, lift the speaker into the bezel ring with the tweeter and woofer pointing
toward the floor, and twist it clockwise until it clicks into place.
Step 1
Fit the loudspeaker into the trim-out ring. Then twist the speaker about 15 degrees clockwise into place. When the
loudspeaker is properly seated, the indicators on the ring and the speaker will line up.
*Important* The indicators must line up to ensure the speaker is properly seated.
Fit into Ring
Twist Clockwise to Lock
Twist into Ring
Step 2
The trim-out ring also features a metal lock to ensure the correct installation of the loudspeaker. Out of the box, the lock will
be in its closed position. Open the lock tab to its unlocked position to remove the speaker from the trim-out ring. Once the
speaker is installed, close the lock tab by pushing it back into place, flush with the perimeter of the ring.
*Important* Push the metal lock tab into its "LOCK" (closed) position after speaker is installed per step 1. This will secure
the installation. (See Figure A)
The loudspeaker must be properly seated, else the metal lock tab will not lock.
*Important* To ensure that the loudspeaker is properly installed, after closing the lock please attempt to rotate the speaker
clockwise. It should not rotate. At that point, you may install the grille.
To uninstall the speaker, push the metal lock tab to its "UNLOCK" (open) position and twist the loudspeaker
counterclockwise. (See Figure B)
Figure A
Figure B
Metal Lock Tab in "UNLOCK" (open) Position
Metal Lock Tab in "LOCK" (closed) Position
Installing the grille
Position the grille so it fits completely over the speaker, then press it against the speaker until the speaker's integral
magnets grab hold of it.
7