Highlander iP-1Xinline Snelstarthandleiding - Pagina 4
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Highlander iP-1Xinline. Highlander iP-1Xinline 4 pagina's. Pickup and preamp for single cone resophonic guitar pickup and preamp for single cone resophonic guitar
Pagina afdrukken
Solder the Pickup Cable to the RCA Connector
Solder the Pickup Cable to the RCA Connector
An RCA Connector is used to connect the pickup to the preamp.
This connector was chosen for its 100% shielding, large contact
area (providing a very low noise connection) and long term
resistance to corrosion.
Pin
White Wire
Cable Clamp
Clamp onto the Heatshrink
Bare Copper
Shield (Ground)
Putting it all together
Putting it all together
4
Restringing
Excess cable is held in place on the back of the guitar with Velcro®. Cables should be loosely coiled. The
Velcro® ensures the cable will not be pinched. AVOID SHARP BENDS, KINKS or TWISTS IN THE CABLES.
The information and graphics contained in this document are the property of Highlander Musical Audio Products. Copying of any kind is prohibited, except for personal use only.
Cover
Heatshrink
Cable
During this final phase of installation it is more important than ever handle the cone with care.
Try to avoid pulling on the pickup cable while plugging in the RCA and applying the Velcro.
3
Replace the Cone
'neck side' of the biscuit
as indicated.
Use small soldering iron and a multicore solder designed for
electronic assembly. Do not use solder with an acid based flux.
Slide the Cover over the Cable.
Tin the INSIDE, back of the Pin (deposit a small amount of solder).
Solder the White Wire INTO the back of the Pin.
Bend the Bare Copper Shield around the Cable Clamp as indicated.
Solder the Shield (do not overheat, it will cause a short in the cable).
Remove any excess Shield with a sharp pair of wire cutters.
Lightly, crimp the Cable Clamp onto the Heatshrink.
Screw the Cover in place and tighten.
Retaining Screw
RCA Connector
Note: The biscuit is shown here
as transparent to reveal the
orientation of the pickup.
1
Plug in the Pickup
2
Apply the Velcro
back of the guitar.
Biscuit
Cone
Pickup Cable
5
Check it out
connect to an amp and
check the sound.
©
Highlander Musical Audio Products 1991-2009