GALLERY 60 Gebruiksaanwijzing - Pagina 15

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GALLERY 60. GALLERY 60 18 pagina's. Canvas stretching machine

3. Make your second cut along the stretcher bar as shown in the photo below.

4. Rotate the artwork 180 degrees and repeat the process. Place the artwork back on the

stretcher plates in the "loaded position" and continue with the remaining stretches.

Troubleshooting

Every machine leaves our facility fully assembled and tested, however, during transit it is

possible that the contents may have experienced some "sudden changes in motion", this

can lead to misalignment issues and even breakage. This section will attempt to resolve

some of the possible issues you may encounter with your machine.

Clamping Bar Not Closing

The Foot Pedal operates like a light switch; in this case it is air and not electricity. When

you first apply air to your machine, with the foot pedal connected, the clamp will close.

Depressing the foot pedal will open the clamp. If your foot pedal does not close please

ensure that you have 120 psi from the compressor and that it is going into the "front" of

the foot pedal and that it is exiting the foot pedal on the right side. A simple test is to

remove the tube going to the hose, apply air from the compressor to the foot pedal and

see if air escapes when the foot pedal is at rest. Stepping on the foot pedal should stop the

air from flowing.

Air is going to the machine but it is still not closing? Call us at 614-861-4582