Dynaudio Focus 20 XD Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dynaudio Focus 20 XD. Dynaudio Focus 20 XD 15 pagina's.
Ook voor Dynaudio Focus 20 XD: Eerste installatie (2 pagina's)
Pagina afdrukken
Owner's Manual Focus XD
Adjusting the
The sound of Focus XD loudspeakers can
be adjusted by increasing or lowering high
loudspeakers'
and low frequencies. Each loudspeaker
can be set separately and individually
sound
based on the room conditions and
personal listening preferences.
Adjusting the low-frequency range
The Speaker Position rotary knob allows
you to lower low frequencies. This allows
you to balance out elevated or cancelled-
out low-frequency signal portions, as they
often occur in living spaces.
►
Set the Speaker Position rotary knob
to the desired position on the back side
of the housing for each loudspeaker.
There are 2 additional intermediate
stages between each of the main
positions that click into place (Neutral,
Wall, and Corner).
18
–– Neutral: free-standing loudspeaker (no
change to sound).
–– Wall: if placed near a wall.
–– Corner: if placed in a corner.
Adjusting the treble
Using the Treble switch on the rear side
of the housing allows you to adjust the
character of the sound to your listening
preferences.
►
Set the Treble switch on the rear side
of the housing to one of three settings:
•
+1 dB: Increase, creates a somewhat
brighter sound.
•
0 dB: Neutral position, no change.
•
–1 dB: Lowering, creates a somewhat
warmer sound.
dynaudio.com/focusxd
Connecting the
►
Use the supplied power cable to
connect the loudspeakers to the mains
voltage supply
voltage and switch it on using the
power switch (POWER) on the rear
(position: I).
Switching on/standby mode
To switch the loudspeaker on from
standby mode:
►
Point the remote control at the
loudspeaker and press the ON button.
The loudspeaker will automatically
search for an audio signal or an
active hub. If found, the signal will be
output. If there is no input signal, the
loudspeaker will go into standby mode
after a certain period.
►
To switch it back on, press ON or start
music playback.
Adjusting the loudspeaker's sound / Connecting the voltage supply
To switch a loudspeaker out of
operation to standby mode:
►
Point the remote control at the
loudspeaker and press the OFF
button. The loudspeaker will go into
standby mode. To completely switch
off the loudspeaker, turn the POWER
switch on the rear to O. However, the
loudspeaker can then no longer be
switched on via the remote control.
Note
Before connecting the device,
check whether the mains voltage
listed on the rear side of the
speakers matches that present at
the installation site.
19