Highnovate BELLA Handmatig - Pagina 3

Blader online of download pdf Handmatig voor {categorie_naam} Highnovate BELLA. Highnovate BELLA 3 pagina's. Remote controlled anchor
Ook voor Highnovate BELLA: Gebruiksaanwijzing (2 pagina's), Gebruiksaanwijzing (2 pagina's)

Pagina afdrukken

PROPER INSTALLATION OF BELLA

The Head (1) – connects to the anchor by a carabiner.

The carabiner should be connected only to the hole on the upper part of

the head (2)

The pin (3) – connects the rope or ladder to the anchor, by connecting

into the head.

The rope (or tag line) (4) – used to connect the head and the pin. The rope

should be inserted from the outer side of the head through the small hole

on the head (5), down trough the head to the hole at the top of the pin (6).

Tie the end so it can not be pulled out.

When installed correctly, pulling the rope should make the pin go up

toward the head and slide into the hole at the bottom of the head until

the two safety pins (7) are in place.

CHECKING THE CONNECTION AFTER THE INSTALLATION:

Make sure both pins are locked in place inside the head (8).

Pull firmly the rope or ladder attached to the pin to make sure the pin is

locked inside the head.

DISASSEMBLY OF THE ANCHOR

Make sure that no one is attached to the anchor.

Press the two pins (7) simultaneously to release the pin from the head.

Hold the rope and let the pin descent slowly to the ground.

Release the head from the anchor point.

[email protected]