Dynaudio BM5 mkIII Gebruikershandleiding - Pagina 3
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dynaudio BM5 mkIII. Dynaudio BM5 mkIII 9 pagina's. Active monitor system
Ook voor Dynaudio BM5 mkIII: Gebruikershandleiding (16 pagina's), Gebruikershandleiding (16 pagina's)
Pagina afdrukken
Introduction
– Be advised that different operating volt-
ages require the use of different types
of line cord and attachment plugs.
– Always observe the local safety regula-
tions. Ensure that the factory-set pow-
er requirements for the device (refer to
the label on the back of the monitor)
corresponds to the mains supply in
your region.
– This equipment should be installed
near the socket outlet and disconnec-
tion of the device should be easily ac-
cessible.
– To completely disconnect from AC
mains, disconnect the power supply
cord from the AC receptacle.
– The mains plug of the power supply
shall remain readily operable.
– Do not install in a confined space.
– Do not open the unit – risk of electric
shock inside.
Caution:
You are cautioned that any change or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
Service
– There are no user-serviceable parts in-
side.
– All service must be performed by qual-
ified personnel.
4
EMC/EMI
This equipment has been tested and found
to comply with the limits for a Class B Dig-
ital device, pursuant to part 15 of the FCC
rules.
These limits are designed to provide rea-
sonable protection against harmful inter-
ference in residential installations. This
equipment generates, uses and can radi-
ate radio frequency energy and, if not in-
stalled and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If the
equipment does cause harmful interfer-
ence to radio or television reception, which
can be determined by turning the equip-
ment off an on, the user is encouraged to
try to correct the interference by one or
more of the following measures.
– Reorient or relocate the receiving an-
tenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
For customers in Canada:
This Class B digital apparatus complies
with Canadian ICES-003.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Cana-
da.
BM5 mkIII
Owner's manual
Introduction
5